ISO 1182:2010 specifies a method of test for determining the non-combustibility performance,under specified conditions, of homogeneous products and substantial components of non-homogeneous products. Information on the precision of the test method is given in Annex A.
ISO 1182:2010 pdf download Read More »
This International Standard specifes requirements for 3-strand hawser-laid and 4-strand shroud-laid ropes,8-strand braided ropes and 12-strand braided ropes for general service made of polyamide, and gives rules for their designation.
ISO 1140:2012 pdf download Read More »
ISO 1101:2012 contains basic information and gives requirements for the geometrical tolerancing of workpieces. It represents the initial basis and defines the fundamentals for geometrical tolerancing. NOTE Other International Standards referenced in Clause 2 and in Table 2 provide more detailed information on geometrical tolerancing.
ISO 1101:2012 pdf download Read More »
This part of ISO 1043 specifies uniform symbols for terms referring to fillers and reinforcing materials. It includes only those symbols that have come into established use, and its main aim is both to prevent the occurrence of more than one symbol for a given filler or reinforcing material and to prevent a given symbol
ISO 1043-2:2011 pdf download Read More »
ISO 1003:2008 specifies requirements for ginger ( Zingiber officinale Roscoe). Annex A specifies a method for the determination of calcium. Recommendations for storage and transport conditions are given in Annex B.
ISO 1003:2008 pdf download Read More »
ISO 927:2009 specifies a general procedure for visual examination, or with magnification not exceeding 10 times, of whole spices for the determination of macro filth. This International Standard is applicable to dehydrated herbs and spices.
ISO 927:2009 pdf download Read More »
This part of ISO 898 specifes mechanical and physical properties of nuts with coarse thread and fne pitch thread made of carbon steel and alloy steel when tested at an ambient temperature range of 10 °C to 35 °C.Nuts conforming to the requirements of this part of ISO 898 are evaluated at that ambient temperature
ISO 898-2:2012 pdf download Read More »
This part of ISO 815 specifies a method for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low temperatures. The method is intended to measure the ability of rubbers of hardness within the range 10 IRHD to 95 IRHD to retain their elastic properties at specified temperatures after prolonged compression
ISO 815-2:2008 pdf download Read More »
This part of ISO 789 specifies a method of determining the turning and clearance diameters of wheeled agricultural tractors. It applies to wheeled agricultural tractors having at least two axles fitted with pneumatic tyres.
ISO 789-3:2015 pdf download Read More »
ISO 730:2009 specifies the dimensions and requirements of the three-point linkage for the attachment of implements or equipment to the rear of agricultural wheeled tractors.
ISO 730:2009 pdf download Read More »