ISO 10133:2012 establishes the requirements for the design, construction and installation of extra-low-voltage direct current (d.c.) electrical systems which operate at nominal potentials of 50 V d.c. or less on small craft of hull length up to 24 m. Conductors that are part of an outboard engine assembly and that do not extend beyond the […]

This International Standard contains tables for environmental tests and test parameters which can be used as a guideline for the selection of environmental tests. These include the selection of standardized tests according to ISO 9022 as well as additional parameters not described in ISO 9022 and necessary for the optical or photonic instruments. Ultimately, these

ISO 10088:2013 specifies the requirements for the design, materials, construction, installation and testing of permanently installed fuel systems as installed for internal combustion engines. It applies to all parts of permanently installed diesel and petrol fuel systems as installed, from the fuel fill opening to the point of connection with the propulsion or auxiliary engine(s)

This International Standard provides guidance on the process of complaints handling related to products within an organization, including planning, design, operation, maintenance, and improvement. The complaints-handling process described is suitable for use as one of the processes of an overall quality management system. This International Standard is not applicable to disputes referred for resolution outside

ISO 9980:2012 specifes the methods of checking the regularity of the grooves and pulleys for V-belts specifed in the system based on effective width. The grooved pulleys can be designed for use with classical or narrow V-belts. The V-belts can be either single or joined units. It is intended to specify the inspection parameters and

ISO 9906:2012 specifes hydraulic performance tests for customers’ acceptance of rotodynamic pumps (centrifugal, mixed fow and axial pumps, hereinafter “pumps”). This International Standard is intended to be used for pump acceptance testing at pump test facilities, such as manufacturers’ pump test facilities or laboratories.

ISO 9841:2013 specifies certain characteristics of essential oil of hyssop (Hyssopus officinalis L. ssp officinalis), with a view to facilitating the assessment of its quality.

ISO 9717:2010 specifies requirements for the processing of ferrous metals, aluminium, zinc,cadmium and their alloys to produce coatings consisting essentially of inorganic phosphates, which are intended to be used in conjunction with supplementary treatments for the protection of the basis metal against corrosion and to provide anti-wear properties to sliding surfaces, adhesion to organic finishes

ISO 9712:2012 specifes requirements for principles for the qualifcation and certifcation of personnel who perform industrial non-destructive testing (NDT). NOTE 1 The term “industrial” implies the exclusion of applications in the feld of medicine.