This part of ISO 9692 specifies types of joint preparation for manual metal arc welding, gas-shielded metal arc welding, gas welding, TIG welding, and beam welding of steel (see Clauses 3 and 4). It applies to joint preparation for full penetration butt welds and for fillet welds. For partial penetration butt welds, types of joint […]

This part of ISO 9448 specifies the main dimensions and tolerances, in millimetres, of guide bushes of form A, plain gliding bushes, type 1, intended for use in press tools and to be mounted in the clamp plate by means of interference fit. It gives guidance on the materials, and specifies the hardness and the

This part of ISO 9445 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30 mm to 8,0 mm and in rolling widths from 600 mm to 2 100 mm. It also applies to slit cold-rolled wide strip in widths less than 600 mm manufactured

This part of ISO 9445 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel narrow strip, in thicknesses of up to and including 3 mm and in rolling widths of less than 600 mm. It also applies to cut lengths taken from such strip. Narrow strip and cut lengths with widths of

This part of ISO 9444 specifies the tolerances on dimensions and form for continuously hot-rolled stainless steel wide strip in actual widths from 600 mm to 2 500 mm and for sheet/plate cut from such strip.

This part of ISO 9444 specifies the tolerances on dimensions and form for continuously hot-rolled stainless steel narrow strip in actual widths of less than 600 mm. It also applies to cut lengths taken from such strip.

This part of ISO 9328 specifies requirements for flat products for pressure purposes made of stainless steels,including austenitic creep-resisting steels, in thicknesses as indicated in Tables 7 to 10. Additionally the requirements of ISO 9328-1 also apply.

This part of ISO 9328 specifies the technical delivery conditions for plates and strip for pressure equipment made of non-alloy and alloy steels as specified in Tables A.1 and B.1. The requirements and definitions of ISO 9328-1 also apply to this part of ISO 9328.