ISO 10928:2009 specifies procedures suitable for the analysis of data which, when converted into logarithms of the values, have either a normal or a skewed distribution. It is intended for use with the test methods and referring standards for glass-reinforced thermosetting plastics (GRP) pipes or fittings for the analysis of properties as a function of […]
ISO 10928:2009 pdf download Read More »
ISO 10878:2013 defines terms used in infrared thermography for non-destructive testing and forms a common basis for standard general use.
ISO 10878:2013 pdf download Read More »
This part of ISO 10816 gives instructions for the evaluation of vibration on rotodynamic pumps for industrial applications with nominal power above 1 kW. It defines the special requirements for evaluation of vibration when the vibration measurements are made on non-rotating parts (bearing housing vibration). It provides specific guidance for assessing the severity of vibration
ISO 10816-7:2009 pdf download Read More »
ISO 10711:2012 defines protocols and message sets between traffic detectors and traffic signal controllers. It is applicable to the various types of traffic detector technologies currently in use for real-time traffic signal controls. The scope of this International Standard is limited to parameter generation to be used for traffic signal control and for the interface
ISO 10711:2012 pdf download Read More »
This part of ISO 10628 defnes graphical symbols for the preparation of diagrams for the chemical and petrochemical industry. It is a collective application standard of the ISO 14617 series. This part of ISO 10628 does not apply to graphical symbols for electrotechnical diagrams; for these, see IEC 60617.
ISO 10628-2:2012 pdf download Read More »
This International Standard specifies requirements for the periodic inspection of acetylene cylinders as required for the transport of dangerous goods and for maintenance in connection with periodic inspection. It applies to acetylene cylinders with and without solvent and with a maximum nominal water capacity of 150 l. NOTE The limitation of 150 l is derived
ISO 10462:2013 pdf download Read More »
ISO 10364:2015 specifies methods for determining the pot life of multi-part adhesives in order to be able to determine whether the pot life conforms to the minimum specified working life required of an adhesive. For the purposes of simplification, the term “pot life” is deemed to have the same meaning as “working life” and will
ISO 10364:2015 pdf download Read More »
This part of ISO 10362 specifies the use of the Karl Fischer method for the determination of water in cigarette smoke condensates. The smoking of cigarettes and collection of mainstream smoke are normally carried out in accordance with ISO 4387. However, the method is also applicable to the determination of water in smoke condensates obtained
ISO 10362-2:2013 pdf download Read More »
ISO 10343:2014, together with ISO 15004-1, specifies requirements and test methods for continuously or digitally indicating ophthalmometers. Certain types of ophthalmometer have sufficient resolution and range (see Table 2) to adequately measure the radii of curvature of contact lenses complying with ISO 18369-3:2006, 4.1.3, and Clause 5. It is assumed that the local corneal front
ISO 10343:2014 pdf download Read More »
The intent of this part of ISO 10318 is to define terms related to functions, products, properties, and other terms used in EN and ISO geosynthetics International Standards. Definitions of terms not included in this part of ISO 10318 can be found in the International Standards describing appropriate test methods.
ISO 10318-1:2015 pdf download Read More »