This International Standard specifies the types and the dimensions of turning tools with carbide tips; it deals only with external tools. It also gives the definition of right-hand and left-hand tools. The shank sections and the inserts used are selected respectively from those defined in ISO 241 and ISO 242. NOTE Internal tools are the […]
ISO 243:2014 pdf download Read More »
ISO 242:2014 specifies the dimensions of carbide tips for turning tools intended to be fixed on the shanks of tools by brazing. NOTE Throwaway carbide indexable inserts are the subject of ISO 883.
ISO 242:2014 pdf download Read More »
This document specifies the dimensions of the following three types of drills: a) parallel shank drills, stub series; b) parallel shank drills, jobber series; c) Morse taper shank drills. It comprises, for each type of drill mentioned above, three tables giving, respectively: a) the dimensions in millimetres; b) the dimension in inches; c) the corresponding
ISO 235:2016 pdf download Read More »
This part of ISO 230 specifies test procedures to evaluate the measuring performance of contacting probing systems (used in a discrete-point probing mode) integrated with a numerically controlled machine tool. It does not include other types of probing systems, such as those used in scanning mode or non-contacting probing systems. The evaluation of the performance
ISO 230-10:2011 pdf download Read More »
This part of ISO 230 specifies methods for testing the accuracy of machine tools, operating either under no-load or under quasi-static conditions, by means of geometric and machining tests. The methods can also be applied to other types of industrial machines. This part of ISO 230 covers power-driven machines, which can be used for machining
ISO 230-1:2012 pdf download Read More »
ISO 204:2009 specifies the method for the uninterrupted and interrupted creep tests and defines the properties of metallic materials which can be determined from these tests, in particular the creep elongation and the time of creep rupture, at a specified temperature. The stress rupture test is also covered by this International Standard, as is the
ISO 204:2009 pdf download Read More »
ISO 188:2011 specifies accelerated ageing or heat resistance tests on vulcanized or thermoplastic rubbers. Two methods are given: Method A: air-oven method using a cell-type oven or cabinet oven with low air speed and a ventilation of 3 to 10 changes per hour; Method B: air-oven method using a cabinet oven with forced air circulation
ISO 188:2011 pdf download Read More »
This part of ISO 179 specifies a method for determining the Charpy impact strength of plastics under defined conditions. A number of different types of specimen and test configurations are defined. Different test parameters are specified according to the type of material, the type of test specimen and the type of notch.
ISO 179-1:2010 pdf download Read More »
This part of ISO 148 specifies the Charpy pendulum impact (V-notch and U-notch) test method for determining the energy absorbed in an impact test of metallic materials. This part of ISO 148 does not apply to instrumented impact testing, which is specified in ISO 14556.
ISO 148-1:2009 pdf download Read More »
ISO 137:2015 specifies the procedure and the measurement conditions for the determination of the wool fibre diameter using a projection microscope. The method is suitable for wool fibres in any form and also for other fibres of reasonably circular cross-section. (In the case of dyed, bleached or finished fibres, the diameter might be different from
ISO 137:2015 pdf download Read More »