ISO 492:2014 specifies dimensional and geometrical characteristics, limit deviations from nominal sizes, and tolerance values to define the interface (except chamfers) of radial rolling bearings. Nominal boundary dimensions are defined in ISO 15, ISO 355 [2] and ISO 8443 [9] . This International Standard does not apply to certain radial bearings of particular types (e.g. […]

ISO 472:2013 defines terms used in the plastics industry, including terms and definitions appearing in plastics standards (of ISO/TC 61) and general terms and definitions of polymer science used in all aspects of plastics technology. NOTE In addition to terms in English and French (two of the three official ISO languages), this vocabulary includes the

ISO 445:2008 defines terms relating to pallets for unit load methods of materials handling. It also includes an informative annex listing general terms relating to materials handling.

ISO 404:2013 specifies the general technical delivery requirements for all steel products covered by ISO 6929, with the exception of steel castings and powder metallurgical products. ISO 10474 describes the inspection documents to be used. Where the delivery requirements agreed upon for the order or specified in the appropriate product or material standard differ from

ISO 377:2013 specifies requirements for the identification, location and preparation of samples and test pieces intended for mechanical tests on steel sections, bars, rod, flat products and tubular products as defined in ISO 6929. If agreed in the order, this International Standard can also apply to other metallic products. These samples and test pieces are

ISO 287:2009 specifies an oven-drying method for the determination of the moisture content of a lot of paper and board. The procedure in Clause 8, describing how the test pieces are drawn from the lot, is performed at the time of sampling. This International Standard is applicable to every type of lot of paper and

ISO 284:2012 specifes the maximum electrical resistance of a conveyor belt and the corresponding test method. The test is intended to ensure that the belt is suffciently conductive to avoid the accumulation of electrical static charge which can be developed during service use.

ISO 249:2014 specifies a method for the determination of the dirt content of raw natural rubber. It is not applicable to dirt present as surface contamination.