ISO 4895:2014 specifies a method for determining the tendency of liquid epoxy resins to crystallize. The tendency to crystallize is determined by observing, at specified time intervals, changes in fluidity and the onset of crystallization.

ISO 4716:2013 specifies certain characteristics of the essential oil of vetiver [Chrysopogon zizanioides (L.) Roberty, syn. Vetiveria zizanioides (L.) Nash], growing in Reunion Island, China, Haiti,Indonesia, Madagascar, Brazil, and Comoros Island in order to facilitate assessment of its quality.

This part of ISO 5610 specifies tool holders with rectangular shank, style V, i.e. with straight shank and cutting edge angle κ r = 72,5° for side cutting. These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for

This document defines the terms used in ultrasonic non-destructive testing and forms a common basis for standards and general use. This document does not cover terms used in ultrasonic testing with phased arrays. NOTE Terms for phased array ultrasonic testing are defined in EN 16018.

ISO 5856:2008 specifies the dimensions of 100° normal countersunk head screws with internal offset cruciform ribbed or unribbed drive, with close or large tolerance normal shank and short or medium length MJ threads, in metallic material, coated or uncoated, with strength classes less than or equal to 1 100 MPa. This International Standard is applicable

This part of IS0 5667 provides guidance on the selection and use of various quality assurance and quality control techniques relating to the manual sampling of surface, potable, waste, marine and ground waters. NOTE The general principles outlined in this part of IS0 5667 might, in some circumstances, be applicable to sludge and sediment sampling.

This document specifies a method for the determination of bending stiffness using the resonance method. This method gives only a single result for each test piece tested, although in general, bending stiffness values may depend on which surface of the material forms the inner surface of the arc resulting from bending forces.

This document specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results.