ISO 5718:2013 specifies requirements for blades used on rotary disk mowers and rotary drum mowers, mounted, semi-mounted, trailed, or self-propelled, as used for forage crop harvesting in agriculture only. It specifies requirements for testing and marking of such blades.
ISO 5718:2013 pdf download Read More »
This part of ISO 5721 specifies the requirements, test procedures and acceptance criteria for the field of vision to the front of the operator of agricultural tractors.
ISO 5721-1:2013 pdf download Read More »
This part of ISO 5751 specifies the tyre size designation, dimensions and load-carrying capacities of metric series motorcycle tyres. It is applicable to such tyres with a height-to-width ratio of 100 % and below. NOTE See ISO 4249 for motorcycle tyres and rims (code-designated series) of rim diameter codes 13 and above,and ISO 6054 for
ISO 5751-2:2010 pdf download Read More »
ISO 5817:2014 provides quality levels of imperfections in fusion-welded joints (except for beam welding) in all types of steel, nickel, titanium and their alloys. It applies to material thickness ≥ 0,5 mm. It covers fully penetrated butt welds and all fillet welds. Its principles can also be applied to partial-penetration butt welds. (Quality levels for
ISO 5817:2014 pdf download Read More »
This part of ISO 5834 specifes the requirements and corresponding test methods for moulded forms,e.g. sheets and rods, made from ultra-high-molecular-weight polyethylene (UHMWPE) for use in the manufacture of surgical implants. This part of ISO 5834 is not applicable to direct-moulded (near net shape), irradiated or fnished products or products manufactured from polyethylene blended with additives or by blending different forms of polyethylene.
ISO 5834-2:2011 pdf download Read More »
This part of ISO 5838 specifies general requirements for metallic skeletal pins and wires for use in bone surgery, excluding wires for binding and twisting.
ISO 5838-1:2013 pdf download Read More »
This part of ISO 5840 outlines an approach for verifying/validating the design and manufacture of a transcatheter heart valve substitute through risk management. The selection of appropriate verification/validation tests and methods are to be derived from the risk assessment. The tests may include those to assess the physical, chemical, biological and mechanical properties of heart
ISO 5840-3:2013 pdf download Read More »
ISO 5951:2013 applies to all grades of hot-rolled steel sheet of higher yield strength with improved formability. The steel is killed, made according to a fine grain practice and has a suitable chemical composition, including microalloying elements, to provide improved formability. The product is intended for the fabrication of parts requiring better formability than is
ISO 5951:2013 pdf download Read More »
ISO 5952:2011 applies to continuously hot-rolled steel sheet (see 3.2) of structural quality with improved atmospheric corrosion resistance, also known as weather-resistant structural steel. It is produced in the grades and classes listed in Table 1. The product is intended for applications where requirements are for mechanical properties and increased resistance to atmospheric corrosion. It
ISO 5952:2011 pdf download Read More »
ISO 6106:2013 specifies a method for determining or checking the grain size of superabrasives (diamond or cubic boron nitride) as used for the manufacture of industrial products,such as grinding wheels and saws. It is applicable to grain size designations as defined in Tables 2 and 3. This International Standard describes the grain size designations, the
ISO 6106:2013 pdf download Read More »