ISO 9224:2012 specifies guiding values of corrosion attack for metals and alloys exposed to natural outdoor atmospheres for exposures greater than one year. This International Standard is intended to be used in conjunction with ISO 9223. Guiding corrosion values for standard structural materials can be used for engineering calculations. The guiding corrosion values specify the […]
ISO 9224:2012 pdf download Read More »
This document specifies the performance specifications and tolerance limits for instruments designed to measure vibration values, for the purpose of assessing human response to vibration. It includes requirements for pattern evaluation, or validation, periodic verification and in situ checks, and the specification of vibration calibrators for in situ checks. Vibration instruments specified in this document
ISO 8041-1:2017 pdf download Read More »
This part of ISO 7967 establishes a vocabulary for fuel systems of reciprocating internal combustion engines. Also, in this part of ISO 7967, the terms and the definitions are classified as follows: — fuel supply system (3.1); — carburetor (3.2); — fuel injection system (3.3).
ISO 7967-11:2014 pdf download Read More »
This document specifies an external protective coating system which is factory-applied to ductile iron pipeline components as specified in ISO 2531, ISO 7186 and ISO 16631. This coating system comprises a zinc-rich paint followed by a finishing layer that can be bituminous paint or synthetic resin compatible with zinc rich paint coating. NOTE ISO 8179-1
ISO 8179-2:2017 pdf download Read More »
This document sets out recommendations designed to maintain rubber and plastics hoses and hose assemblies, prior to use, in a condition as close as possible to the condition they were in when they were received and to obtain the expected service life. NOTE It is intended that this document be used in conjunction with any
ISO 8331:2016 pdf download Read More »
ISO 9043:2008 specifies a measuring method for determining the moments of inertia of the moped and of the moped/rider combination. It applies to two-wheeled mopeds. Other measuring methods can be used if it is demonstrated that the results are equivalent. Measurement results obtained exclusively by the method described in this International Standard (see Annex A)
ISO 9043:2008 pdf download Read More »
This document specifies a method for the determination of the fatigue indexes of cross-country skis (i.e.the resistance of the skis to changes of bottom camber height or irreversible damage) after a bending test with cyclic loading. It is applicable to cross-country skis with a nominal length of 160 cm to 215 cm.
ISO 7798:2017 pdf download Read More »
ISO 7781:2008 specifies methods for the determination of the soap and organic-acid content of raw styrene-butadiene rubber (SBR). Method A is the titration method using indicator reagent. Method B is the titration method using an autotitrator or pH-meter. The methods depend on the extraction of the organic acids and soaps from the rubber by means
ISO 7781:2008 pdf download Read More »
This document provides the method of calculation of the thermal resistance and thermal transmittance of building components and building elements, excluding doors, windows and other glazed units,curtain walling, components which involve heat transfer to the ground, and components through which air is designed to permeate. The calculation method is based on the appropriate design thermal
ISO 6946:2017 pdf download Read More »
ISO 8574:2008 specifies pressure impulse and burst test procedures for determining and classifying the impulse fatigue strengths of bent tubes used in aerospace hydraulic systems. The procedures are intended for qualification purposes of high- and low-pressure system tubing or for the evaluation of new materials for hydraulic system tubing. NOTE Requirements for tubing used in
ISO 8574:2008 pdf download Read More »