This part of ISO 8253 specifies relevant test signal characteristics, requirements for free, diffuse, and quasi-free sound fields, and procedures for sound field audiometry using pure tones, frequency-modulated tones or other narrow-band test signals presented by means of one or more loudspeakers. The primary purpose is the determination of hearing threshold levels in the frequency […]
ISO 8253-2:2009 pdf download Read More »
ISO 8251:2011 specifies the following three test methods: a) abrasive-wheel-wear test method, determining the wear resistance and the wear index of anodic oxidation coatings on flat specimens of aluminium and its alloys; b) abrasive jet test method, comparing the resistance to abrasion of anodic oxidation coatings on aluminium and its alloys with that of a
ISO 8251:2011 pdf download Read More »
This part of ISO 8124 specifies requirements and test methods for activity toys for domestic family use intended for children under 14 years to play on or in. Products covered by this part of ISO 8124 include swings, slides, seesaws, carousels, rocking toys,climbing frames, fully enclosed toddler swing seats and other products intended to bear
ISO 8124-4:2014 pdf download Read More »
ISO 8098:2014 specifies safety and performance requirements and test methods for the design, assembly and testing of fully assembled bicycles and sub-assemblies for young children. It also provides guidelines for instructions on the use and care of the bicycles. This International Standard is applicable to bicycles with a maximum saddle height of more than 435
ISO 8098:2014 pdf download Read More »
ISO 8015:2011 specifies fundamental concepts, principles and rules valid for the creation,interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) and verification. This International Standard applies to the interpretation of GPS indications on all types of drawings. For the purposes of this International Standard,
ISO 8015:2011 pdf download Read More »
ISO 8013:2012 specifes a method for the determination of creep in vulcanized rubber continuously subjected to compressive or to shear forces. The standard cannot be used for intermittent deformation of rubber.
ISO 8013:2012 pdf download Read More »
ISO 8009:2014 specifies the minimum requirements and test methods to be used for reusable diaphragms made from natural rubber and silicone rubber. These diaphragms are intended for contraceptive use. This International Standard is not applicable to other vaginal contraceptive barriers, such as those known as cervical caps, vaginal sponges, and vaginal sheaths.
ISO 8009:2014 pdf download Read More »
This part of ISO 8000 describes fundamental concepts of information and data quality, and how these concepts apply to quality management processes and quality management systems. It also specifies prerequisites for measuring information and data quality when executed within quality management processes and quality management systems.
ISO 8000-8:2015 pdf download Read More »
This part of ISO 7919 gives guidelines for applying evaluation criteria of shaft vibration under normal operating conditions, measured at or close to the bearings of coupled industrial machines. These guidelines are presented in terms of both steady running vibration and any amplitude changes which can occur in these steady values. The numerical values specified
ISO 7919-3:2009 pdf download Read More »
ISO 7870-2:2013 establishes a guide to the use and understanding of the Shewhart control chart approach to the methods for statistical control of a process. This International Standard is limited to the treatment of statistical process control methods using only the Shewhart system of charts. Some supplementary material that is consistent with the Shewhart approach,
ISO 7870-2:2013 pdf download Read More »