ISO 8637:2010 specifies requirements for haemodialysers, haemodiafilters, haemofilters and haemoconcentrators, hereinafter collectively referred to as “the device”, for use in humans. This International Standard is not applicable to: ⎯ extracorporeal blood circuits; ⎯ plasmafilters; ⎯ haemoperfusion devices; ⎯ vascular access devices; ⎯ blood pumps; ⎯ pressure monitors for the extracorporeal blood circuit; ⎯ air detection […]
ISO 8637:2010 pdf download Read More »
ISO 8624:2011 specifies a measuring system for spectacle frames and related terminology. It is applicable to fronts which are intended to be symmetrical.
ISO 8624:2011 pdf download Read More »
This part of ISO 8600 specifies requirements for rigid bronchoscopes and their endoscopic accessories used in the practice of anaesthesia and medical endoscopy.
ISO 8600-2:2015 pdf download Read More »
This part of ISO 8573 specifies purity classes of compressed air with respect to particles, water and oil,independent of the location in the compressed air system at which the air is specified or measured. This part of ISO 8573 provides general information about contaminants in compressed air systems as well as links to the other
ISO 8573-1:2010 pdf download Read More »
This part of ISO 8528 defines terms and specifies design and performance criteria arising out of the combination of a Reciprocating Internal Combustion (RIC) engine and an Alternating Current (a.c.)generator when operating as a unit. It applies to a.c. generating sets driven by RIC engines for land and marine use, excluding generating sets used on
ISO 8528-5:2013 pdf download Read More »
ISO 8496:2013 specifies a method for a ring tensile test of tubes to reveal surface and internal defects by subjecting the test piece to strain until fracture occurs. This test may also be used to assess the ductility of tubes. The ring tensile test is applicable to tubes having an outside diameter exceeding 150 mm
ISO 8496:2013 pdf download Read More »
ISO 8492:2013 specifies a method for determining the ability of metallic tubes of circular cross-section to undergo plastic deformation by flattening. It may also be used to reveal the defects in the tubes. This International Standard is applicable to tubes having an outside diameter no greater than 600 mm and a thickness no greater than
ISO 8492:2013 pdf download Read More »
ISO 8469:2013 specifies general requirements and physical tests for non-fire-resistant hoses for conveying petrol or petrol blended with ethanol and diesel fuel or diesel fuel blended with FAME, designed for a working pressure not exceeding 0,34 MPa for hoses with inner diameter up to and including 10 mm and 0,25 MPa for hoses up to
ISO 8469:2013 pdf download Read More »
ISO 8405:2013 specifies the dimensions and tolerances, in millimetres, of ejector sleeves with cylindrical head which are used in compression and injection moulds and in die casting dies. It also gives material guidelines and hardness requirements, and specifies the designation of ejector sleeves with cylindrical head.
ISO 8405:2013 pdf download Read More »
ISO 8310:2012 specifies the essential requirements and verification procedures for automatic tank thermometers (ATTs) consisting of platinum resistance thermometers (PRT) and an indicating device used for custody transfer measurement of liquefied natural gas, liquefied petroleum and chemical gases on board ships. Temperature detectors other than PRT are considered acceptable for use in the custody transfer
ISO 8310:2012 pdf download Read More »