This part of ISO 7870 presents key elements and philosophy of the control chart approach, and identifies a wide variety of control charts (including those related to the Shewhart control chart, those stressing process acceptance or online process adjustment, and specialized control charts). It presents an overview of the basic principles and concepts and illustrates […]
ISO 7870-1:2014 pdf download Read More »
ISO 7866:2012 specifies minimum requirements for the material, design, construction and workmanship, manufacturing processes and tests at time of manufacture of refillable seamless aluminium alloy gas cylinders of water capacities up to and including 150 litres for compressed, liquefied and dissolved gases for worldwide use (normally up to 65 °C).
ISO 7866:2012 pdf download Read More »
This part of ISO 7755 specifies the common characteristics of hardmetal burrs of various styles, in solid design or with brazed shank. The main dimensions of the cutting part of hardmetal burrs are dealt with individually in ISO 7755-2,ISO 7755-3, ISO 7755-4, ISO 7755-5, ISO 7755-6, ISO 7755-7, ISO 7755-8, ISO 7755-9, ISO 7755-10, ISO
ISO 7755-1:2013 pdf download Read More »
ISO 7743:2011 specifies methods for the determination of the compression stress-strain properties of vulcanized or thermoplastic rubber using a standard test piece, a product or a part of a product. Four procedures are given: using standard test piece A with the metal plates lubricated (method A); using standard test piece A with the metal plates
ISO 7743:2011 pdf download Read More »
ISO 7668:2010 specifies methods for the measurement of specular reflectance and specular gloss of flat samples of anodized aluminium using geometries of 20° (Method A), 45° (Method B), 60° (Method C) and 85° (Method D); and of specular reflectance by an additional 45° method (Method E) employing a narrow acceptance angle. The methods described are
ISO 7668:2010 pdf download Read More »
This part of ISO 7637 specifies test methods and procedures to ensure the compatibility to conducted electrical transients of equipment installed on passenger cars and commercial vehicles fitted with 12 V or 24 V electrical systems. It describes bench tests for both the injection and measurement of transients. It is applicable to all types of
ISO 7637-2:2011 pdf download Read More »
This part of ISO 7622 specifies a method for the determination of the elongation of steel cords constituting the carcass of conveyor belts, when subjected to a force corresponding to 10 % and 60 % of the specified tensile strength. It applies exclusively to conveyor belts with a steel carcass. NOTE A method for the
ISO 7622-1:2013 pdf download Read More »
This part of ISO 7539 covers procedures for designing, preparing and using precracked specimens for investigating susceptibility to stress corrosion. It gives recommendations for the design, preparation and use of precracked specimens for investigating susceptibility to stress corrosion. Recommendations concerning notched specimens are given in Annex A. The term “metal” as used in this part
ISO 7539-6:2011 pdf download Read More »
ISO 7504:2015 defines terms related to gas analysis, with the main focus on terms related to calibration gas mixtures for use in gas analysis and gas measurements. It does not cover terms which relate only to specific applications.
ISO 7504:2015 pdf download Read More »
This part of ISO 7494 specifies requirements and test methods concerning a) the configuration of dental unit connections to the compressed air supply, water supply, suction supply, and wastewater drain plumbing, b) the materials, design, and construction of the compressed air and water system within the dental unit, c) the quality for incoming water and
ISO 7494-2:2015 pdf download Read More »