ISO 12233:2014 specifies methods for measuring the resolution and the SFR of electronic still-picture cameras. It is applicable to the measurement of both monochrome and colour cameras which output digital data or analog video signals.

ISO 12212:2012 establishes the classification of thermoplastics materials in pipe form and specifies the material designation. It also specifies a method for calculating the design stress. It is applicable to materials intended for pipes and fittings for pressure applications. NOTE 1 Classification, minimum design coefficient and calculation method are based on the resistance to internal

ISO 12162:2009 establishes the classification of thermoplastics materials in pipe form and specifies the material designation. It also specifies a method for calculating the design stress. It is applicable to materials intended for pipes and fittings for pressure applications. NOTE 1 Classification, minimum design coefficient and calculation method are based on the resistance to internal

ISO 12111:2011 is applicable to the TMF testing of uniaxially loaded metallic specimens under strain control. Specifications allow for any constant cyclic amplitude of mechanical strain and temperature with any constant cyclic mechanical strain ratio and any constant cyclic temperature-mechanical strain phasing. NOTE A list and sketch of the most common cyclic types is shown

ISO 12100:2010 specifies basic terminology, principles and a methodology for achieving safety in the design of machinery. It specifies principles of risk assessment and risk reduction to help designers in achieving this objective. These principles are based on knowledge and experience of the design, use,incidents, accidents and risks associated with machinery. Procedures are described for

ISO 11938:2012 provides procedures for electron microprobe elemental-mapping analysis using wavelength-dispersive spectrometry. The choice between mapping with the electron beam moving digitally across the specimen (electron beam mapping) and mapping with stage movement only (large-area mapping) is assessed. It describes fve types of data processing: the raw X-ray intensity data method, the k-value method,the calibration

ISO 11837:2011 specifes performance requirements and a corresponding test method for saw chain shot guarding systems on the harvester heads and grip saws of forestry machines. It is applicable only to saw chain breakage on the cutting side of the guide bar. NOTE Other test methods and test apparatus can be used if shown to