Welcome to this website, where you can query the price of ISO standards, the latest version of ISO standards and the basic introduction of ISO standards.
This part of ISO 230 specifies methods for testing the accuracy of machine tools, operating either under no-load or under quasi-static conditions, by means of geometric and machining tests. The methods can also be applied to other types of industrial machines. This part of ISO 230 covers power-driven machines, which can be used for machining […]
ISO 230-1:2012 pdf download Read More »
ISO 204:2009 specifies the method for the uninterrupted and interrupted creep tests and defines the properties of metallic materials which can be determined from these tests, in particular the creep elongation and the time of creep rupture, at a specified temperature. The stress rupture test is also covered by this International Standard, as is the
ISO 204:2009 pdf download Read More »
ISO 188:2011 specifies accelerated ageing or heat resistance tests on vulcanized or thermoplastic rubbers. Two methods are given: Method A: air-oven method using a cell-type oven or cabinet oven with low air speed and a ventilation of 3 to 10 changes per hour; Method B: air-oven method using a cabinet oven with forced air circulation
ISO 188:2011 pdf download Read More »
This part of ISO 179 specifies a method for determining the Charpy impact strength of plastics under defined conditions. A number of different types of specimen and test configurations are defined. Different test parameters are specified according to the type of material, the type of test specimen and the type of notch.
ISO 179-1:2010 pdf download Read More »
This part of ISO 148 specifies the Charpy pendulum impact (V-notch and U-notch) test method for determining the energy absorbed in an impact test of metallic materials. This part of ISO 148 does not apply to instrumented impact testing, which is specified in ISO 14556.
ISO 148-1:2009 pdf download Read More »
ISO 137:2015 specifies the procedure and the measurement conditions for the determination of the wool fibre diameter using a projection microscope. The method is suitable for wool fibres in any form and also for other fibres of reasonably circular cross-section. (In the case of dyed, bleached or finished fibres, the diameter might be different from
ISO 137:2015 pdf download Read More »
ISO 124:2008 specifies methods for the determination of the total solids content of natural rubber latex concentrate and synthetic rubber latices. These methods are not necessarily suitable for latex from natural sources other than the Hevea Brasiliensis, for vulcanized latex, for compounded latex or for artificial dispersions of rubber.
ISO 124:2008 pdf download Read More »
This part of ISO 105 specifies a method for determining the resistance of the colour of textiles of all kinds and in all forms to immersion in water.
ISO 105-E01:2013 pdf download Read More »
This part of ISO 105 specifies a method for determining the resistance of the colour of textiles, of all kinds and in all forms, to the combined effect of wetting with acid or alkaline artificial perspiration solutions and an artificial light source representing natural daylight (D65).
ISO 105-B07:2009 pdf download Read More »
This part of ISO 96 specifies the principal dimensions of HZ- and J-rings, and the mass and tolerance on the mass, of the appropriate travellers for HZ- and J-rings employed on ring spinning and ring twisting machines.It also specifies the method of designation of the travellers.
ISO 96-2:2009 pdf download Read More »