ISO Standards

ISO 377:2013 specifies requirements for the identification, location and preparation of samples and test pieces intended for mechanical tests on steel sections, bars, rod, flat products and tubular products as defined in ISO 6929. If agreed in the order, this International Standard can also apply to other metallic products. These samples and test pieces are […]

ISO 287:2009 specifies an oven-drying method for the determination of the moisture content of a lot of paper and board. The procedure in Clause 8, describing how the test pieces are drawn from the lot, is performed at the time of sampling. This International Standard is applicable to every type of lot of paper and

ISO 284:2012 specifes the maximum electrical resistance of a conveyor belt and the corresponding test method. The test is intended to ensure that the belt is suffciently conductive to avoid the accumulation of electrical static charge which can be developed during service use.

ISO 249:2014 specifies a method for the determination of the dirt content of raw natural rubber. It is not applicable to dirt present as surface contamination.

This International Standard specifies the types and the dimensions of turning tools with carbide tips; it deals only with external tools. It also gives the definition of right-hand and left-hand tools. The shank sections and the inserts used are selected respectively from those defined in ISO 241 and ISO 242. NOTE Internal tools are the

ISO 242:2014 specifies the dimensions of carbide tips for turning tools intended to be fixed on the shanks of tools by brazing. NOTE Throwaway carbide indexable inserts are the subject of ISO 883.

This document specifies the dimensions of the following three types of drills: a) parallel shank drills, stub series; b) parallel shank drills, jobber series; c) Morse taper shank drills. It comprises, for each type of drill mentioned above, three tables giving, respectively: a) the dimensions in millimetres; b) the dimension in inches; c) the corresponding