AS Standards

This Standard specifies minimum energy performance standards (MEPS) requirements for gas water heaters intended for use with natural gas, liquefied petroleum gas (LPG) and simulated natural gas (SNG) up to a nominal gas consumption of 50 MJ/h for storage types and 250 MJ/h for instantaneous types and which fall within the scope of AS 4552. […]

This Technical Report sets out guidance for the selection, use, care and maintenance of clothing designed to provide protection to the wearer. The guidance set out in this Technical Report are intended for all types of protective clothing and may be completed by additional specific guidelines for clothing designed to address specific risks.

This Standard specifies the method for determining the performance characteristics of electric refrigerating appliances suitable for connection to mains power, whatever the cooling technology. It does not specify safety requirements, which appear in AS/NZS 3350.2.24 and AS/NZS 60335.2.24. Appliances covered by this Standard include refrigerators, refrigerator/freezers and freezers.

This Standard specifies the requirements that apply to the use of the Regulatory Compliance Mark (RCM) on products to indicate compliance with electromagnetic compatibility regulations in Australia and New Zealand. It is intended to be read in conjunction with AS/NZS 441 7.1 ,which specifies the RCM and sets out general rules for its use.

This standard specifies the requirements for the Regulatory Compliance Mark (RCM) and its placement on electrical and electronic equipment to indicate compliance with particular regulations applicable to aspects of the equipment as detailed in this standard. It is to be read in conjunction with AS/NZS 441 7.1 and with the EESS, Equipment Safety Rules,relevant Australian

This Standard specifies the requirements for the use of a trademark, called the Regulatory Compliance Mark (RCM)。on electrical products to indicate compliance with regulations applicable to aspects of the product as covered in other parts of this Standard.

This Standard sets out area source sampling protocols to be followed when using a flux chamber for the determination of odour or other atmospheric contaminants. The method provides a measure of area source odour and atmospheric contaminant flux emission rate, in units of ou.m³/m².s and g/m².s, respectively. NOTE: Some indirect measurement techniques are described in