AS Standards

This standard specifies requirements for materials used in factory cast polyurethane sealing elements used in joints for drainage, sewerage and rainwater systems and non-potable water supply for continuous flow up to 45 °C. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the […]

This standard specifies requirements for materials used for moulded seals only of thermoplastic elastomers (TPE) used in joints of: 1) thermoplastic piping systems for non pressure waste water discharge (intermittent flow up to 95 °C) inside buildings; 2) thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow up to 45 °C and intermittent

This Standard sets out minimum requirements for the design, construction, installation and commissioning of mechanical smoke control systems in buildings. Specific methods of smoke control are defined and the appropriate requirements specified for each. The design information given in this Standard in respect to hot layer smoke control is based on a single axisymmetric plume,

This Standard specifies requirements for appliances used for the hoisting of materials or materials and personnel involved in lifting the materials that are not covered by other parts of AS 1418. It is complementary to AS 1418.1 but requirements given herein take precedence over corresponding requirements in AS 1418.1. NOTES: 1 General guidance on the

This Standard specifies requirements for the design and manufacture of turnouts, switches and crossings and their components. NOTE: Purchasing and usage guidelines are given in Appendix A, including information to be supplied by Purchasers and Suppliers.