Welcome to this website, where you can query the price of AS standards, the latest version of AS standards and the basic introduction of AS standards.
After the seventh paragraph of the test specification insert the following variation: During and after the tests the no-load output voltage of an accessible safety extra-low voltage outlet or connector or Universal Serial Bus (USB) outlet shall not have increased by more than 3 V or 10% of its no-load output voltage in normal use, […]
AS NZS 60335.1:2020 pdf download Read More »
This part of IEC 60079-29 specifies general requirements for construction, testing and performance, and describes the test methods that apply to portable, transportable and fixed apparatus for the detection and measurement of flammable gas or vapour concentrations with air. The apparatus, or parts thereof, are intended for use in potentially explosive atmospheres (see 3.1 .8)
AS NZS 60079.29.1:2008 pdf download Read More »
AS NZS 60076.3:2008 applies to single-phase and three-phase oil-immersed power transformers (including auto-transformers), with the exception of certain small and special transformers, as defined in the scope of IEC 60076-1 . It identifies transformer windings to their highest voltage for equipment U m associated with their corresponding rated insulation levels and details the relevant applicable
AS NZS 60076.3:2008 pdf download Read More »
This International Standard specifies requirements for classification of wire electrodes, wires, rods and all-weld metal deposits in the as-welded condition and in the post-weld heat-treated (PWHT) condition for gas shielded metal arc welding and tungsten inert-gas welding of high-strength steels with a minimum yield strength greater than 500 MPa, or a minimum tensile strength greater
AS NZS 16834:2013 pdf download Read More »
This part of ISO/IEC 1 4763 specifies requirements for the planning, installation and operation of telecommunications cabling and cabling infrastructures including cabling, pathways, spaces and telecommunications bonds (other than that specified in ISO/IEC 301 29) in support of generic cabling standards and associated documents.
AS NZS 14763.2:2020 pdf download Read More »
This document specifies requirements for the maximum amount and, in some cases, the maximum concentration of certain substances and mixtures used in experimental sets for chemistry and related activities.
AS NZS 8124.4:2020 pdf download Read More »
This Standard provides guidelines for the conduct and declaration of verification, validation and assurance of an organization’s environmental and related performance.
AS NZS 5911:2013 pdf download Read More »
This Standard specifies and gives guidance on the site and site approval, the design, testing and approval of equipment, the management of the operation, the operating procedures, the emergency provisions and procedures, registration of operating staff, certification and audit of a bungy jumping operation.
AS NZS 5848:2000 pdf download Read More »
This Standard specifies the minimum energy performance standards (MEPS) and energy rating label requirements for computer monitors. The power consumption of the computer monitors is measured according to the current version of AS/NZS 5815.1. NOTES: 1 In Australia, specific product requirements are set out in a legislative instrument called the Greenhouse and Energy Minimum Standards
AS NZS 5815.2:2013 pdf download Read More »
This Standard specifies requirements and means of conformance for the design, installation, repair,alteration, modification, replacement and commissioning of LP Gas installations in caravans and boats for non-propulsive purposes. The requirements cover — (a) caravans; (b) mobile homes, mobile holiday homes, campervans and motor homes; (c) transportable structures with fixed gas installations, other than transportable homes
AS NZS 5601.2:2020 pdf download Read More »