This part of ISO 3506 specifies the mechanical properties of tapping screws made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower temperatures. It applies to tapping screws with threads from ST2,2 up to […]
ISO 3506-4:2009 pdf download Read More »
This part of ISO 3506 specifies the mechanical properties of set screws and similar fasteners not under tensile stress made of austenitic stainless steel, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower temperatures. This part of ISO 3506 applies to set screws and similar
ISO 3506-3:2009 pdf download Read More »
This part of ISO 3506 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower temperatures. This part of ISO 3506 applies to nuts: ⎯ with nominal thread
ISO 3506-2:2009 pdf download Read More »
This part of ISO 3452 specifies the testing requirements particular to applications at low temperatures (lower than + 10 °C) as well as the method for qualification of suitable testing products. It applies only to materials qualified for the relevant temperature range used in accordance with the manufacturer’s instructions.
ISO 3452-6:2008 pdf download Read More »
This part of ISO 3452 specifies the testing requirements particular to applications at higher temperatures (over 50 °C) and also the method for qualification of suitable testing products. It applies only to materials qualified for the relevant temperature range used in accordance with the manufacturer’s instructions.
ISO 3452-5:2008 pdf download Read More »
ISO 3452-3:2013 describes two types of reference blocks: — Type 1 reference blocks are used to determine the sensitivity levels of both fluorescent and colour contrast penetrant product families; — Type 2 reference blocks are used for routine assessment of the performance of both fluorescent and colour contrast penetrant testing. The reference blocks are to
ISO 3452-3:2013 pdf download Read More »
ISO 3376:2011 specifies a method for determining the tensile strength, elongation at a specified load and elongation at break of leather. It is applicable to all types of leather.
ISO 3376:2011 pdf download Read More »
This International Standard specifies the general characteristics, performance and critical dimensions necessary for interchangeability and compatibility with other components, of forged steel eyebolts grade 4 for general lifting purposes. These eyebolts can be used for axial and inclined loading. This International Standard specifies the dimensions of the eyes of eyebolts permitting direct connection with shackles
ISO 3266:2010 pdf download Read More »
ISO 3074:2014 specifies a method for determining the dichloromethane-soluble matter in combed wool sliver. Its use can be extended to wool in other forms. It should be recognized that extraction with dichloromethane under the prescribed conditions does not completely remove all the fatty material present in a sample of wool. A further amount, possibly material
ISO 3074:2014 pdf download Read More »
ISO 3059:2012 specifes the control of the viewing conditions for magnetic particle and penetrant testing. It includes minimum requirements for the illuminance and UV-A irradiance and their measurement. It is intended for use when the human eye is the primary detection aid. This International Standard does not cover the use of actinic blue light sources.
ISO 3059:2012 pdf download Read More »