This part of ISO 5660 specifies a method for assessing the heat release rate and dynamic smoke production rate of specimens exposed in the horizontal orientation to controlled levels of irradiance with an external igniter. The heat release rate is determined by measurement of the oxygen consumption derived from the oxygen concentration and the flow […]
ISO 5660-1:2015 pdf download Read More »
This part of ISO 5611 applies for cartridges type A, with hole(s) for fastening screw(s), of style J, i.e. with cutting edge angle κ r = 93° for end cutting. Cartridges are intended to be used with indexable inserts made of hard metal, ceramic or other cutting materials and are primarily mounted to be used
ISO 5611-4:2015 pdf download Read More »
This part of this ISO 5611 applies for cartridges type A, with hole(s) for fastening screw(s), of style F, i.e.with cutting edge angle κ r = 90° for end cutting. Cartridges are intended to be used with indexable inserts made of hard metal, ceramic, or other cutting materials and are primarily mounted to be used
ISO 5611-2:2015 pdf download Read More »
This International Standard specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of
ISO 5603:2011 pdf download Read More »
This International Standard defines terms relating to sensory analysis. NOTE 1 Grammatical forms of terms have been indicated where it was felt useful to do so. It applies to all industries concerned with the evaluation of products by the sense organs. The terms are given under the following headings: 1) general terminology; 2) terminology relating
ISO 5492:2008 pdf download Read More »
ISO 5431:2013 specifies requirements, methods of sampling and methods of test for wet blue leather produced from goat skins tanned without hair and with the use of basic chromium sulfate as the primary tanning agent.
ISO 5431:2013 pdf download Read More »
ISO 5359:2014 specifies requirements for low-pressure hose assemblies intended for use with the following medical gases: — oxygen, — nitrous oxide, — medical air, — helium, — carbon dioxide, — xenon, — specified mixtures of the gases listed above, — oxygen-enriched air, — air for driving surgical tools, — nitrogen for driving surgical tools, and
ISO 5359:2014 pdf download Read More »
ISO 5270:2012 specifes the relevant International Standards to be used for the determination of physical properties of laboratory sheets made of all kind of pulps. It is applicable to laboratory sheets prepared in accordance with ISO 5269-1, ISO 5269-2 or ISO 5269-3. In this International Standard, it is left to the pulp producer and the
ISO 5270:2012 pdf download Read More »
ISO 5208:2015 specifies examinations and tests that a valve manufacturer needs to act upon in order to establish the integrity of the pressure boundary of an industrial metallic valve and to verify the degree of valve closure tightness and the structural adequacy of its closure mechanism. This International Standard is intended to be applied in
ISO 5208:2015 pdf download Read More »
ISO 5208:2008 specifies examinations and tests that a valve manufacturer needs to act upon in order to establish the integrity of the pressure boundary of an industrial metallic valve and to verify the degree of valve closure tightness and the structural adequacy of its closure mechanism. This International Standard is to be applied in conjunction
ISO 5208:2008 pdf download Read More »