ISO 23279:2010 specifies how to characterize embedded indications by classifying them as planar or non-planar. This procedure is also suitable for indications that break the surface after removal of the weld reinforcement.

ISO 23278:2015 specifies acceptance levels for indications from imperfections in ferromagnetic steel welds detected by magnetic particle testing. The acceptance levels are primarily intended for use during manufacture examination. NOTE They can also be used for in-service inspection.

ISO 22967:2010 specifies the terminology, test procedures and general requirements for the construction and operation of automatic forced draught gas burners, and the provision of related control and safety devices. It is applicable to the following: a) automatic gas burners (hereinafter called “burners”) fitted with a combustion air fan that are equipped as described in

ISO 20869:2010 specifies a method for the determination of the water soluble contents for outsoles,insoles, lining and insocks.

ISO 20639:2015 specifies a method for the quantitative determination of pantothenic acid, excluding bound forms, in infant formula and adult nutritionals (i.e. powders) using ultra high performance liquid chromatography and tandem mass spectrometry method (UHPLC-MS/MS).

This document specifies the dimensions and tolerances for electrode holders and of spot welding electrode caps, where a locking taper is used.

ISO 23205:2014 specifies the minimum design and performance requirements for an instructional seat and restraint designed for limited use by a trainer or trainee or service person inside an enclosed cab of an agricultural tractor. The instructional seat is neither intended for, nor is it designed for use by, children.

This document specifies the minimum requirements and test methods of Artemisia argyi leaf for medicinal use. It is suitable for identification and quality control of this herbal medicine.

This document specifies the requirements and test methods for dental amalgam products supplied to the user in capsules, pre-dosed with dental amalgam alloy and dental mercury in quantities suitable for the creation of a single dental restoration. This document specifies the requirements and test methods for dental amalgam alloys that are suitable for the preparation