This section of IEC 60695 offers guidance on the following: a) General aspects of corrosion damage test methods; b) Methods of measurement of corrosion damage; c) Consideration of test methods; d) Relevance of corrosion damage data to hazard assessment. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic […]
IEC 60695-5-1:2002 pdf download Read More »
IEC 60684-3-209:2003 outlines the requirements for a specific type of general-purpose, flexible, flame-retardant, heat-shrinkable polyolefin sleeving, which has a nominal minimum shrink ratio of 2:1. This sleeving has been deemed suitable for use at temperatures of up to 125 °C. It is typically available in internal diameters up to 102 mm and comes in various
IEC 60684-3-209:2003 pdf download Read More »
IEC 60622:2002 outlines the marking, testing, and requirements for sealed nickel-cadmium prismatic secondary single cells. NOTE: In this context, “prismatic” refers to cells with rectangular sides and bases. In cases where an IEC standard specifies test conditions and requirements for cells used in specialized applications that conflict with this standard, the former will take precedence.
IEC 60622:2002 pdf download Read More »
Section of IEC 60544 introduces a classification system designed to facilitate the selection and indexing of insulating materials that are intended for use in the radiation-laden environments found in nuclear reactor plants, fuel processing plants, irradiation centers, particle accelerators, and X-ray equipment. The classification system offers a range of parameters that delineate the suitability of
IEC 60544-4:2003 pdf download Read More »
This section of IEC 60512 pertains to the electrical overload testing of mated contact pairs in connectors. The aim of this test is to establish a standardized method for evaluating the performance of these mated contact pairs when subjected to an electrical overload current for a specified duration ranging from 100 milliseconds to 20 seconds.
IEC 60512-10-4:2003 pdf download Read More »
This section of IEC 60512, when required by the detail specification, is utilized for testing electromechanical components within the purview of IEC Technical Committee 48. This test may also be applied to similar devices when specified in a detail specification. The objective of this test is to establish a standard method for determining the capability
IEC 60512-6-4:2002 pdf download Read More »
This section of IEC 60512 is employed for testing electromechanical components within the jurisdiction of IEC Technical Committee 48, as mandated by the detail specification. Additionally, this test may be applicable to similar devices when indicated in a detail specification. The purpose of this test is to establish a standard method for evaluating the ability
IEC 60512-6-2:2002 pdf download Read More »
This section of IEC 60512 is utilized for testing connectors of electronic equipment within the scope of IEC Technical Committee 48, when required by the detail specification. This test may also be applied to similar devices when specified in a detail specification. The objective of this test is to establish a standard method for determining
IEC 60512-4-1:2003 pdf download Read More »
This section of IEC 60512 is utilized for testing electromechanical components as specified by the detail specification, within the framework of IEC Technical Committee 48. This test may also be applicable to similar devices when indicated in a detail specification. The purpose of this test is to establish a standard method for measuring the electrical
IEC 60512-2-1:2002 pdf download Read More »
This section of IEC 60455 details the requirements for cured epoxy resinous compounds filled with quartz, applicable to types EP-F-1 through EP-F-7. It is anticipated that additional materials beyond quartz may be incorporated into the specification at a later stage.
IEC 60455-3-2:2003 pdf download Read More »