This Standard specifies requirements for the performance of showers for bathing.

This document defines welding positions for testing and production, for butt and fillet welds, in all product forms. Annex A gives examples of the limits of the slope of a weld axis and the rotation of the weld face about the weld axis for welding positions in production welds. Annex B gives a comparison of

This Standard specifies the performance requirements for acrylonitrile butadiene styrene (ABS) compounds (ABS 120, ABS 140, ABS 160 and ABS 180), pipes and fittings for the conveyance of liquids under pressure in applications above and below ground. The Standard contains dimensions for three ranges of pipe sizes, Series 1, Series 2 and Series 3.Series 1

This Standard specifies requirements for welded carbon steel LP Gas fuel vessels of total internal volume not greater than 500 L, and for welded stainless steel LP Gas fuel vessels of total internal volume not greater than 200 L, intended for automotive and marine installations. Appendix A specifies additional requirements to allow the supply of

This Standard sets out safety requirements for cord extension sets intended for use at low voltage, including cord extension sets with a separable reeling or coiling device. Cord extension sets incorporating an integral reeling or coiling device are excluded from this Standard and are covered by AS/NZS 3105.

This Standard sets out safety requirements for cord extension sets intended for use at low voltage, including cord extension sets with separable reeling or coiling device. Cord extension sets incorporating an integral reeling or coiling device are excluded from this Standard and are covered by AS/NZS 3105.