1.1 This metric practice guide is based on the Intemational System of Units (SD) as defined in the US Federal Register notice of July 28, 1998, “Metric System of Measurement: Interpretation of the International System of Units for the United States”. (Other source documents and style guides are referenced in Annex D.) This guide contains […]
AWS A1.1:2016 pdf download Read More »
1.1 This specification prescribes requirements for the clasifcation of carbon and low-alloy steel fux cored electrodes for fux cored are welding (FCAW), either with or without shielding gas, and carbon and low-alloy steel metal cored electrodes for gas metal are welding (GMAW). Carbon and lowalloy fux cored electrodes had previously been cassifed solely under AWS
AWS A5.36:2016 pdf download Read More »
1.1 This specification prescribes requirements for the classification, based on underwater wet welding test and associated evaluation, of covered electodes for underwater wet shielded metal arc welding. Requirements for certification of test results are also shown herein. The specfication covers frritic steel, austenitic stainless steel, and nickel fller metals plus any auxiliary coatings applied over
AWS A5.35:2016 pdf download Read More »
1.2 Scope. This guide essentially provides an introduction to visual examination of welding. These examinations fall into three categories based on the time they are performed, as follows: (1) prior to welding, (2) during welding, and (3) after welding. An extensive treatment is provided on weld surface conditions, including reference to frequently used ter-minologies associated
AWS B1.11M:2015 pdf download Read More »
1.1 Scope. This specification prescribes the requirements for the classifcation of brazing fluxes used with brazing or braze welding fller metals such as those classified in AWS A5.8M/A5.8, Specification for Filler Melals for Brazing and Braze Welding.
AWS A5.31M:2012 pdf download Read More »
1.1 This specification prescribes requirements for the classification of zirconium and zirconium-alloy electrodes and rods for gas metal arc, gas tungsten arc, and plasma arc welding. 1.2 This standard makes use of both U.S. Customary Units and the International System of Units (SI). The latter are shown within brackets (SI) or in appropriate columns in
AWS A5.24:2014 pdf download Read More »
1.1 This Recommended Practice provides test procedures for evaluating the capability of a cable to withstand different flexing motions. One or more of these tests may be used depending on the specific application.
UL RP 5770:2018 pdf download Read More »
1 .1 This standard provides minimum requirements for fixed and transportable open path toxic gas detection equipment. 1 .2 This standard specifies the construction, performance and testing of open path (line-of-sight) gas detectors that sense the presence of toxic gas concentrations in air. 1 .3 For equipment used for sensing the presence of multiple gases,
UL 920004:2017 pdf download Read More »
This clause of Part 1 is applicable, except as follows: Addition: This standard applies to chain saws for cutting wood and designed for use by one person. This standard does not cover chain saws designed for use in conjunction with a guide-plate and riving knife or in any other way such as with a support
UL 62841-4-1:2020 pdf download Read More »
This clause of Part 1 is applicable, except as fllows: Addition: This part of IEC 62841 applies to transportable drills, with manually fed axial movement of the spindle,having a maximum chuck capacity of 13 mm. NOTE 101 Transportable drills are also known as bench drills or drill presses. This part of IEC 62841 does not
UL 62841-3-13:2018 pdf download Read More »