1.1 These test methods cover the chemical analysis of manganese-copper alloys having chemical compositions within the following limits

1.1 This specification sets forth the requirements for duplex,types E, J, K, N and T thermocouple wire, insulated with E-glass, S-glass, amorphous silica fiber or polycrystalline fiber. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.1 This guide provides design details that should be con-sidered in the design of buildings that include operable partitions. Operable partitions are those that can be quickly put in place or removed and stored to provide flexibility in the size of spaces typically used for meetings or social functions. 1.1.1 The guide primarily discusses details

1.1 This practice is a supplement to Form and Style for ASTM Standards 2 , which shall be consulted in writing all ASTM standards. 1.2 This practice contains, directly or by reference, all ofthe information required to comply with the policy on fire stan-dards and the additional guidelines recommended by Commit-tee E05.

1.1 This specification covers the general requirements for the standard smooth tire for pavement testing. The tire covered by this specification is intended for evaluation oftire-pavement friction. 1.2 The terminology in this specification is consistent with Terminology E867.

1.1 This specification covers the general requirements for the standard rib tire for pavement skid-resistance testing. The tire covered by this specification is for use in evaluation of tire-pavement friction. 1.2 The terminology in this specification is consistent with Terminology E867.

1.1 This practice covers the procedure for the performanceof axial force controlled fatigue tests to obtain the fatiguestrength of metallic materials in the fatigue regime where thestrains are predominately elastic, both upon initial loading andthroughout the test. This practice is limited to the fatiguetesting of axial unnotched and notched specimens subjected toa constant amplitude, periodic

1.1 This test method describes the measurement of heat transfer rate using a thermal capacitance-type calorimeter which assumes one-dimensional heat conduction into a cylin-drical piece of material (slug) with known physical properties.

1.1 This test method covers the simultaneous determination of 20 alloying and residual elements in carbon and low-alloy steels by spark atomic emission vacuum spectrometry in the mass fraction ranges shown (Note 1).

1.1 This practice covers methods for instrumenting low-conductivity specimens for testing in an environment subject to rapid thermal changes such as produced by rocket motors,atmospheric re-entry, electric-arc plasma heaters, and so forth.Specifically, practices for bare-wire thermocouple instrumen-tation applicable to sheath-type thermocouples are discussed.