1.1 This test method covers a procedure for measuring the compressive strength ofsprayed fire-resistive material (SFRM) applied to a rigid substrate. These fire-resistive materials include sprayed fibrous and cementitious materials applied directly in contact with these structural members. The test method is applicable to laboratory procedure. 1.2 The values stated in either SI units or […]

1.1 This test method covers a procedure for determining the effect ofimpact loading on the bonding ofsprayed fire-resistive material (SFRM) applied to the underside of steel floor deck.These materials include sprayed fibrous and cementitious materials applied directly in contact with the structural mem-bers. The test method is applicable only to laboratory proce-dures. 1.2 The values

1.1 This test method is used to determine the resistance to attrition of granular carriers and granular pesticides. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.1 These test methods are used to determine bulk density of granular carriers and granular pesticides by measuring either free-fall bulk density (Test MethodA) or loose-fill bulk density (Test Method B). 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system

1.1 This test method presents general procedures for sam-pling and sampling practice for granular carriers and granular pesticides. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.1 This guide 2 covers techniques for both dry and wetmagnetic particle testing, a nondestructive method for detect-ing cracks and other discontinuities at or near the surface inferromagnetic materials. Magnetic particle testing may beapplied to raw material, semifinished material (billets, blooms,castings, and forgings), finished material and welds, regardlessof heat treatment or lack thereof. It is

1.1 This fire-test-response standard covers determination of the specific optical density of smoke generated by solid materials and assemblies mounted in the vertical position in thicknesses up to and including 1 in. (25.4 mm). 1.2 Measurement is made of the attenuation of a light beam by smoke (suspended solid or liquid particles) accumulating within a

1.1 This test method covers a screening technique to deter-mine volatile content of materials when exposed to a vacuum environment. Two parameters are measured: total mass loss (TML) and collected volatile condensable materials (CVCM).An additional parameter, the amount of water vapor regained (WVR), can also be obtained after completion of exposures and measurements required for

1.1 This practice covers a procedure for the rating of rectangular steel sections by immersion ultrasonic techniques.Its purpose is to provide information on the content of large inclusions or clusters of small inclusions for determining the suitability of a steel lot for bearing applications. This practice in no manner defines or establishes limits of acceptability.

1.1 This practice covers ultrasonic examination of materials by the pulse-echo technique, using continuous coupling of angular incident ultrasonic vibrations. 1.2 This practice shall be applicable to development of an examination procedure agreed upon by the users of the practice.