1.1 This specification provides the minimum requirementsfor design, construction, performance, and testing of detona-tion flame arresters intended to protect against deflagrations,overdriven (unstable) detonations, stable detonations, and sta-bilized burning. 1.2 This specification is intended for detonation flamearresters protecting systems containing gases or vapors ofliquids with flash points 140°F [60°C] (closed cup) or less. Thetests in this […]

1.1 This specification covers requirements for non-pressure polyolefin pipe and fitings for drainage, waste, and vent applications. Nom.1- This specification does not include requirements for pipe and ftings intended to be used to vent combustion gases.

1.1 Applicability: 1.1.1 This specification identifies the industry standards which have been determined by consensus to demonstrate compliance to the requirements (“the Rules”) for Level 1, 2, 3, 4 Normal Category Aeroplanes.

1.1 The gel content of pipe and tubing produced from crosslinked polyethylene plastics as described in Specification F876 and other pipe or tubing standards is determined by extracting with solvents such as xylenes. A test method for quantitative determination of gel content is described herein.The method is applicable to PEX pipe and tubing of all

1.1 This specification addresses the airworthiness require-ments for aeroplane handling characteristics in flight and on ground and water. 1.2 The material was developed through open consensus of international experts in general aviation. This information was created by focusing on Normal Category aeroplanes; however, the content may be more broadly applicable, and should not be unduly

1.1 This specification covers eye protectors, designed for use by players of racket sports (racquetball, squash, tennis),that minimize or significantly reduce injury to the eye and adnexa due to impact and penetration by racket-sport rackets and balls. Protective eyewear offers protection only to the eyes and does not protect other parts of the head.

1.1 This specification covers minimum requirements for the control, indication, and operational characteristics of propul-sion systems. It was developed based on propulsion system installed on aeroplanes, but may be applicable to other appli-cations as well.

1.1 This test method evaluates the energy consumption and cooking performance of cook-and-hold ovens. The food ser-vice operator can use this evaluation to select a cook-and-hold oven and understand its energy consumption. 1.2 This test method is applicable to gas and electric cook-and-hold ovens.

1.1 This specification covers requirements for the com-pound and physical characteristics of cork floor tile. This standard specifies the requirements for cork floor coverings made from agglomerated composition cork supplied in tile form, which are designed to be used with a factory finish or an in situ finish, or both.

1.1 This standard method describes the technology and testing procedures that can be used to detect seal defects in the size range of 1 mm and characterize seal quality in a variety of packaging styles using airborne ultrasound technology. 1.2 This test method does not purport to be the only method for measurement of seal