1.1 This specification establishes the requirements for seam-less copper tube in coils, suitable for use in refrigeration and air conditioning or other uses, such as oil lines and gasoline lines. 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that […]

1.2 Units—The values stated in inch-pound units and the values stated in SI units in Table 5 are to be regarded as standard, except for grain size which is stated in metric units only. The values given in parentheses are mathematical con-versions to SI units and are provided for information only and are not considered

1.1 This specification covers wrought alloy UNS N06333 in the form of hot-finished and cold-finished bars and flats intended for heat resisting applications and general corrosive service. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for

1.1 This specification covers unalloyed and alloyed tanta-lum plate, sheet, and strip as follows. 1.1.1 R05200, unalloyed tantalum, electron-beam furnace or vacuum-arc melt, or both, 1.1.2 R05400, unalloyed tantalum, powder-metallurgy consolidation,

1.1 This specification covers welded UNS N06625, 2 UNS N06219 2 and UNS N08825 2 pipe in the annealed condition (temper) for general corrosion applications. 1.2 This specification covers pipe sizes in schedules shown in the Permissible Variations in Outside Diameter and Wall Thickness for Welded Pipe table of Specification B775.

1.1 This specification covers electrical contact components made from copper tungsten by powder metallurgical proce-dures.

1.1 This specification covers UNS N08028 and N08029 scamless cold-finished or hot-finished pipe and tube intended for general corrosive service. The general requirements are covered in Specification B829.

1.1 This guide prescribes a method for preparing cemented carbides for metallographic examination.

1.1 This specification covers the requirements for a coating that is a mixture of cadmium and tin mechanically deposited on metal products. The coating is provided in various thicknesses up to and including 12 um.