1.1 This specification a covers the requirements for automated, controlled shot peening of metallic articles prior to electrolytic or aulocatalytic deposition of nickel or chromium,or as a final finish, using shot made of cast steel, conditioned cut wire, or ceramic media. The process is applicable to those materials on which test work has shown it […]

1.1 This guide covers procedures for reducing the suscep-tibility in some steels to hydrogen embrittlement or degrada-tion that may arise in the finishing processes. 1.2 The heat treatment procedures established herein may be effective for reducing susceptibility to hydrogen embrittle-ment. This heat-treatment procedure shall be used after plating operations but prior to any secondary conversion

1.1 This specification covers the requirements for elecrode-posited zine cobalt alloy coatings on metals. 1.2 The following precautionary caveat pertains to the test method portion only, Section 8, of this specification: This standard does nor purport 10 address all of the safery concerms, if any. associated with is use. I is the respousibility of the

1.1 This specification establishes the requirements for Type GAS seamless Copper UNS No. C12200 tube for use in above ground natural gas and liquified petroleum (LP) gas fuel distribution systems, commonly assembled with flared fittings or brazed joints. N OTE 1—Tube temper, size, and joining method are determined by installation code requirements.

1.1 This specification covers aluminum/single input wire (SIW) stranded conductors made from round or shaped wires for use in covered or insulated electrical wires or cables. These conductors shall be composed of one or more roller or die compacted layers of helically applied wires (Explanatory Note 1, Explanatory Note 2, and Explanatory Note 3).

1.1 This specification covers bare compact round stranded conductors made from uncoated copper wires of a single input wire (SIW) diameter for general use in covered or insulated electrical wires or cables. These conductors shall be con-structed with one or more layers of helically laid compacted wires (Explanatory Note 1, Note 2, and Note 3).

1.1 This test method covers single shear testing of thin wrought and cast aluminum alloy products to determine shear ultimate strengths. It is intended for products that are too thin to be tested according to Test Method B769. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in

1.1 This test method covers procedures and equipment for determining the relative buildup of corrosion and tarnish films (including oxides) on metal surfaces by the constant-current coulometric technique, also known as the cathodic reduction method.

1.1 This specification covers a variety of copper base powder metallurgy (PM) structural materials, including those used in applications where high electrical conductivity is required. It includes a classification system, or material desig-nation code. With the classification system, this specification includes chemical composition and minimum tensile yield strength. N OTE 1—Paragraphs 6.1 and 8.1 govern

1.1 This specification establishes the requirements for two wall thickness schedules of specially cleaned, straight lengths of seamless copper tube, identified as Types K and L, suitable for medical gas systems. The tube shall be installed in conformance with the requirements of the National Fire Protection Association (NFPA) Standard 99, Gas and Vacuum Systems (NFPA)