1.1 This test method covers the measurement of the com-pressive stresses (Note 1) developed by fired porcelain enamels using the loaded-beam method. NOTE 1—Although some may interpret the calculations that are used in this test method as indicating compressive load, it is commonly referred to as compressive stress within the porcelain enamel industry.

1.1 This specification covers the composition, size,dimensions, and physical properties of glass fiber blanket thermal and acoustical insulation for use up to 700°F (370°C) in aircraft applications. For specific applications, the maximum temperature shall be agreed upon between the supplier and the purchaser.

1.1 This test method covers a laboratory procedure for determining the effects of heat aging on weight loss, cracking,and chalking of cured-in-place elastomeric joint sealants (single- and multi-component) for use in building construction. 1.2 This standard does not purport to oddress all of the sqfety concerns, if any, associated with its use. It is the

1.1 This practice was developed for electric-arc furnace graphite electrodes, and covers a procedure and equipment for obtaining core samples from electrodes in a manner that does not destroy the electrode nor prevent its subsequent use as originally intended. However, the minimum clectrode diameter, for which extraction of a core sample using this practice does

1.1 This test method covers two test procedures (A and B) for the determination of the compressive strength of fired whiteware materials. 1.2 Procedure A is generally applicable to whiteware prod-ucts of low- to moderately high-strength levels (up to 150 000 psi or 1030 MPa).

1.1 This test method covers procedures for determining the stress-optical coefficient of glass, which is used in photoelastic analyses. In Procedure A the optical retardation is determined for a glass fiber subjected to uniaxial tension. In Procedure B the optical retardation is determined for a beam of glass of rectangular cross section when subjected to

1.1 These test methods cover or give reference to proce-dures for subsampling and for chemical, mass spectrometric,spectrochemical, nuclear, and radiochemical analysis of ura-nium hexafluoride (UF). Most of these test methods are in routine use to determine conformance to UF。specifications in the Enrichment and Conversion Facilities.

1.1 These test methods cover procedures for the chemical and spectrochemical analysis of nuclear grade silver-indium-cadmium (Ag-In-Cd) alloys to determine compliance with specifications.

1.1 This specification covers the minimum requirements for the installation of interior nonstructural steel framing and furring members designed to receive screw-attached gypsum panel products. The steel framing and furring members cov-ered in this specification are limited to those complying with Specification C645.

1.1 This test method covers the lesting of carbon and graphite in tension to obtain the tensile stress-strain behavior,to failure, from which the ultimate strength, the strain to falure, and the clastic moduli may be calculated as may be required for engineering applications. Table 2 lists suggested sizes of specimens that can be used in