1.1 This specification covers the general requirements and physical properties of reflective insulations for use in building applications. These insulation materials consist of one or more low emittance surfaces, such as metallic foil or metallic deposits, unmounted or mounted on substrates. Reflective insulations derive thermal performance from surfaces with an emittance of 0.1 or less, […]

1.1 This specification covers minimum requirements for steel drill screws for use in fastening gypsum panel products or metal plaster bases to steel members from 0.033 in. (0.84 mm) to 0.112 in. (2.84 mm) in thickness. 1.2 This specification also covers physical properties and test methods for determining performance requirements.

1.1 This practice provides information for the use of seal-ants to reduce sound transmission characteristics of interior walls, ceilings, and floors by proper application of sealants to joints, voids, and penetrations normally found in building construction, which are commonly referred to as “flanking paths.”

1.1 This practice covers a procedure for preparing refractory specimens usually containing calcium aluminate cement with or without metal fibers by cold nozzle-mix gunning. Specimens prepared in accordance with this practice are intended for use in standardASTM test methods required for evaluating gunned materials.

1.1 This test method covers determination of the pullout strength of hardened concrete by measuring the force required to pull an embedded metal insert and the attached concrete fragment from a concrete test specimen or structure. The insert is either cast into fresh concrete or installed in hardened concrete. This test method does not provide

1.1 This specification covers natural or manufactured aggre-gate for use in job-mixed base and finish-coat full thickness portland cement-based plasters. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.1 This specification covers the recommended design cri-teria and manufacturing practices for monolithic or sectional precast concrete utility structures. Concrete pipe and box culverts are not covered under this specification. Also, precast concrete manholes covered in Specification C478 are excluded from this specification.

1.1 This practice describes the minimum live loads and dead loads to be applied when designing monolithic or sectional precast concrete utility structures. Concrete pipe, box culverts,and material covered in Specification C478 are excluded from this practice. NOTE 1- For additional information see AASHTO Standard Specifica-tion for Highway Bridges, Seventeenth Edition. NOTE 2- -The purchaser

1.1 This practice describes the minimum live loads and dead louds to be applied when designing monolithic or sectional precast concrete utility structures. Concrete pipe, box culverts,and material covered in Specifcation C478 are excluded from this practice. . Note 1- For additional information see AASHTO Standard Specifeca- tio for Highway Bridges, Seventeenth Edition. Note 2-

1.1 This test method covers the determination of the elastic properties of ceramic whiteware materials. Specimens of these materials possess specific mechanical resonance frequencies which are defined by the elastic moduli, density, and geometry of the test specimen. Therefore the elastic properties of a material can be computed if the geometry, density, and me-chanical resonance