1.1 This practice covers a method for characterizing surface wind speed, wind direction, peak one-minute speeds, peak three-second and peak one-minute speeds, and standard devia-tions of fluctuation about the means of speed and direction. 1.2 This practice may be used with other kinds of sensors if the response characteristics of the sensors, including their signal […]

1.1 This specification covers mineral-colloid-stabilized,concentrated, emulsified, refined coal tar suitable for use as weather-protective and aliphatic-solvent resistant coatings over bituminous pavements such as those found at airports, parking areas, and driveways. The specification for this material was previously covered by Federal Specification RP355. N OTE 1—Dilute the concentrated emulsion after testing and prior to application

1.1 This practice covers techniques to accelerate weathering effects of factory-coated embossed hardboard using apparatus described in Practice G 90. 1.2 This practice is based upon Procedure B, Cycle 1 of Practice G 90 (concentrated natural sunlight with periodic surface water spray) plus a soak-freeze-thaw cycle (see 5 of this practice).

1.1 This specification covers “fiberglass” (glass-fiber-reinforced thermosetting-resin) fittings for use with filament wound or centrifugally cast fiberglass pipe, or both, in sizes 1 in. through 16 in. for pipe manufactured to Specification D 2996 or D 2997, or both.

1.1 These test methods cover the determination of specific resistance (resistivity) of liquid paints, solvents, and other fluids in the range of 0.6 to 2640 MV-cm. 1.2 Test Method A describes a procedure for making resis-tance tests with a commonly used paint application 2 test assembly (Fig. 1).

1.1 This practice covers laboratory procedures for pre-paring an etched, polished surface of granular and block samples of coal for examination with a microscope using reflected light illumination.

1.1 This guide provides an approach for both the calculation and the substantiation of recycled content of finished packag-ing paper and paperboard products. Amass balance approach is recommended for use by manufacturers since no physical or chemical test method is currently available to determine absolute recycled content of a finished paper product. Calcu-lations are based

1.1 The values stated in SI units are to be regarded as the standard.

1.1 This test method is used to make comparative assess-ments of the securing or locking effect of adhesives used in threaded assemblies. 1.2 This standard does not purport to address all of the safety concerns, if anny, associated with its use. It is the responsibility of the user of this standard to establish appro-priate safety

1.1 This test method covers the determination ofthe torque-tension relationship (lubricity) of adhesives used for locking and sealing threaded fasteners. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility ofthe user of this standard to establish appro-priate safety and health practices