Welcome to this website, where you can query the price of ISO standards, the latest version of ISO standards and the basic introduction of ISO standards.
This part of ISO 10628 defnes graphical symbols for the preparation of diagrams for the chemical and petrochemical industry. It is a collective application standard of the ISO 14617 series. This part of ISO 10628 does not apply to graphical symbols for electrotechnical diagrams; for these, see IEC 60617.
ISO 10628-2:2012 pdf download Read More »
This International Standard specifies requirements for the periodic inspection of acetylene cylinders as required for the transport of dangerous goods and for maintenance in connection with periodic inspection. It applies to acetylene cylinders with and without solvent and with a maximum nominal water capacity of 150 l. NOTE The limitation of 150 l is derived
ISO 10462:2013 pdf download Read More »
ISO 10364:2015 specifies methods for determining the pot life of multi-part adhesives in order to be able to determine whether the pot life conforms to the minimum specified working life required of an adhesive. For the purposes of simplification, the term “pot life” is deemed to have the same meaning as “working life” and will
ISO 10364:2015 pdf download Read More »
This part of ISO 10362 specifies the use of the Karl Fischer method for the determination of water in cigarette smoke condensates. The smoking of cigarettes and collection of mainstream smoke are normally carried out in accordance with ISO 4387. However, the method is also applicable to the determination of water in smoke condensates obtained
ISO 10362-2:2013 pdf download Read More »
ISO 10343:2014, together with ISO 15004-1, specifies requirements and test methods for continuously or digitally indicating ophthalmometers. Certain types of ophthalmometer have sufficient resolution and range (see Table 2) to adequately measure the radii of curvature of contact lenses complying with ISO 18369-3:2006, 4.1.3, and Clause 5. It is assumed that the local corneal front
ISO 10343:2014 pdf download Read More »
The intent of this part of ISO 10318 is to define terms related to functions, products, properties, and other terms used in EN and ISO geosynthetics International Standards. Definitions of terms not included in this part of ISO 10318 can be found in the International Standards describing appropriate test methods.
ISO 10318-1:2015 pdf download Read More »
ISO 10133:2012 establishes the requirements for the design, construction and installation of extra-low-voltage direct current (d.c.) electrical systems which operate at nominal potentials of 50 V d.c. or less on small craft of hull length up to 24 m. Conductors that are part of an outboard engine assembly and that do not extend beyond the
ISO 10133:2012 pdf download Read More »
This International Standard contains tables for environmental tests and test parameters which can be used as a guideline for the selection of environmental tests. These include the selection of standardized tests according to ISO 9022 as well as additional parameters not described in ISO 9022 and necessary for the optical or photonic instruments. Ultimately, these
ISO 10109:2015 pdf download Read More »
ISO 10088:2013 specifies the requirements for the design, materials, construction, installation and testing of permanently installed fuel systems as installed for internal combustion engines. It applies to all parts of permanently installed diesel and petrol fuel systems as installed, from the fuel fill opening to the point of connection with the propulsion or auxiliary engine(s)
ISO 10088:2013 pdf download Read More »
This part of ISO 10079 specifies safety and performance requirements for medical suction equipment powered from a vacuum or positive pressure gas source generating venturi suction. It applies to equipment connected to medical gas pipeline systems or cylinders and venturi attachments. Annex D illustrates the three parts of ISO 10079 by providing a schematic for
ISO 10079-3:2014 pdf download Read More »