ISO Standards

ISO 12111:2011 is applicable to the TMF testing of uniaxially loaded metallic specimens under strain control. Specifications allow for any constant cyclic amplitude of mechanical strain and temperature with any constant cyclic mechanical strain ratio and any constant cyclic temperature-mechanical strain phasing. NOTE A list and sketch of the most common cyclic types is shown […]

ISO 12100:2010 specifies basic terminology, principles and a methodology for achieving safety in the design of machinery. It specifies principles of risk assessment and risk reduction to help designers in achieving this objective. These principles are based on knowledge and experience of the design, use,incidents, accidents and risks associated with machinery. Procedures are described for

ISO 11938:2012 provides procedures for electron microprobe elemental-mapping analysis using wavelength-dispersive spectrometry. The choice between mapping with the electron beam moving digitally across the specimen (electron beam mapping) and mapping with stage movement only (large-area mapping) is assessed. It describes fve types of data processing: the raw X-ray intensity data method, the k-value method,the calibration

ISO 11837:2011 specifes performance requirements and a corresponding test method for saw chain shot guarding systems on the harvester heads and grip saws of forestry machines. It is applicable only to saw chain breakage on the cutting side of the guide bar. NOTE Other test methods and test apparatus can be used if shown to

ISO 11676:2014 defines terms and marking of pattern disks and patterns chains for warp knitting machines.

communication betweentippedusersdesign suppliersindexable cutting edges with the purpose of simplifying

ISO 11443:2014 specifies methods for determining the fluidity of plastics melts subjected to shear stresses at rates and temperatures approximating to those arising in plastics processing.Testing plastics melts in accordance with these methods is necessary since the fluidity of plastics melts is generally not dependent solely on temperature, but also on other parameters, in particular

ISO 11426:2014 specifies a cupellation method (fire assay) for the determination of gold in gold jewellery alloys. The gold content of the alloys should preferably lie between 333 and 999 parts per thousand (‰). The procedure is applicable specifically to gold alloys incorporating silver, copper, and zinc. Some modifications are indicated where nickel and/or palladium