ISO Standards

ISO 20958:2013 sets out guidelines for the online techniques recommended for the purposes of condition monitoring and diagnostics of machines, based on electrical signature analysis. This International Standard is applicable to three-phase induction motors.

ISO 20774:2013 is applicable to the determination of carbon monoxide present in the sidestream smoke from cigarettes. The described method is specified using the ISO 3308 smoking parameters (puff volume, duration and frequency) and butt length, but it is technically compatible with other smoking regimes. NOTE The method may not be directly adaptable to other

This document specifies the determination of the total chlorine content of aromatic isocyanates used in the preparation of polyurethanes. The difference between the total chlorine content and the hydrolyzable chlorine content (see ISO 15028) is a measure of the process solvents left in the product.Both test methods are applicable to a variety of organic compounds,

ISO 20032:2013 specifies a method for evaluating the tensile properties of metallic superplastic materials which exhibit what is called “Fine-Grained Superplasticity”, without significant work-hardening or dynamic microstructure evolution, by means of a tensile test at constant cross-head velocity, for flat-form test pieces, without an extensometer attached.

This document specifies a method to measure the solar heat gain coefficient of complete windows and doors. This document applies to windows and doors a) with various types of glazing (glass or plastic; single or multiple glazing; with or without low emissivity coatings, and with spaces filled with air or other gases), b) with opaque

This document provides the definition of a single MXF file design for Stereoscopic Picture content wrapping. It also defines a new Composition Playlist (CPL) extension element to reference such Stereoscopic Picture Track File.

ISO 23279:2010 specifies how to characterize embedded indications by classifying them as planar or non-planar. This procedure is also suitable for indications that break the surface after removal of the weld reinforcement.

ISO 23278:2015 specifies acceptance levels for indications from imperfections in ferromagnetic steel welds detected by magnetic particle testing. The acceptance levels are primarily intended for use during manufacture examination. NOTE They can also be used for in-service inspection.

ISO 22967:2010 specifies the terminology, test procedures and general requirements for the construction and operation of automatic forced draught gas burners, and the provision of related control and safety devices. It is applicable to the following: a) automatic gas burners (hereinafter called “burners”) fitted with a combustion air fan that are equipped as described in