Welcome to this website, where you can query the price of ISO standards, the latest version of ISO standards and the basic introduction of ISO standards.
This part of ISO 21549 defines a general structure for the different types of data to be defined in other parts of ISO 21549 using UML notation. ISO 21549 defines data structures held on patient healthcards compliant with the physical dimensions of ID-1 cards, as defined by ISO/IEC 7810.
ISO 21549-1:2013 pdf download Read More »
ISO 21216:2012 covers the open systems interconnection (OSI) Layer 1 physical layer (PHY) air interface for a communications medium operating in the 60 GHz millimetric frequency range by providing the parameters for medium range, medium-to-high speed wireless communications in the ITS sector. It specifes the parameters required to interface the Layer 1 of such a
ISO 21216:2012 pdf download Read More »
ISO 21210:2012 specifies networking protocol functionalities related to IPv6 networking between two or more ITS stations communicating over the global Internet communication network. The International Standard assumes that the reader is familiar with IETF specifications found in “Request for Comments” (RFCs) of individual IPv6 protocol blocks used within this International Standard. This International Standard does
ISO 21210:2012 pdf download Read More »
This part of ISO 20785 gives the basis for the measurement of ambient dose equivalent at flight altitudes for the evaluation of the exposures to cosmic radiation in civilian aircraft.
ISO 20785-3:2015 pdf download Read More »
This part of ISO 20785 gives the conceptual basis for the determination of ambient dose equivalent for the evaluation of exposure to cosmic radiation in civilian aircraft and for the calibration of instruments used for that purpose.
ISO 20785-1:2012 pdf download Read More »
This part of ISO 20783 specifies a test method to assess the stability of emulsions within the category HFAE,as defined in ISO 6743-4, made up with waters having clearly-defined concentrations of salts. This method is applicable only to HFAE fluids and not to HFAS fluids.
ISO 20783-1:2011 pdf download Read More »
This part of ISO 20765 specifies a method to calculate volumetric and caloric properties of natural gases,manufactured fuel gases, and similar mixtures, at conditions where the mixture may be in either the homogeneous (single-phase) gas state, the homogeneous liquid state, or the homogeneous supercritical (dense-fluid) state. NOTE 1 Although the primary application of this document
ISO 20765-2:2015 pdf download Read More »
ISO 20633:2015 specifies a method for the simultaneous quantitative determination of vitamin E (a-tocopherol and a-tocopheryl acetate) and vitamin A (13-cis and all-trans isomers of retinyl palmitate and retinyl acetate) present in all forms of infant and adult formulas (powders, ready-to-feed liquids and liquid concentrates). Retinol is not used for fortification purposes and therefore is
ISO 20633:2015 pdf download Read More »
This part of ISO 20492 specifies methods for testing the edge seal strength, and partially testing the moisture and gas permeation through sealants, of glass insulating units. Other parts of ISO 20492 designate two approaches to the standardization of insulating glass units: approach 1 is intended for use in markets such as North America; and
ISO 20492-4:2010 pdf download Read More »
ISO 20361:2015 specifies all the information necessary to carry out efficiently and under standardized conditions the determination, declaration, and verification of the airborne noise emission of liquid pumps or pump units (see 4.1). It specifies the noise measurement methods and the operating and mounting conditions that shall be used for the test. Noise emission characteristics
ISO 20361:2015 pdf download Read More »