Welcome to this website, where you can query the price of ISO standards, the latest version of ISO standards and the basic introduction of ISO standards.
ISO 22665:2012 is applicable to instruments and methods used for measuring the axial length of the human eye. It defnes minimum requirements for such instruments and systems and defnes test methods and procedures to verify that a system or instrument qualifes as an axial length measuring device in accordance with this International Standard.
ISO 22665:2012 pdf download Read More »
ISO 22413:2010 applies to sterilized single use transfer sets that are used for pharmaceutical preparations.
ISO 22413:2010 pdf download Read More »
ISO 22322:2015 provides guidelines for developing, managing, and implementing public warning before, during, and after incidents. This International Standard is applicable to any organization responsible for public warning. It is applicable at all levels, from local up to international. Before planning and implementing the public warning system, risks and consequences of potential hazards are assessed.
ISO 22322:2015 pdf download Read More »
This part of ISO 22197 specifies a test method for the determination of the air-purification performance of materials that contain a photocatalyst or have photocatalytic films on the surface, usually made from semiconducting metal oxides, such as titanium dioxide or other ceramic materials, by continuous exposure of a test piece to the model air pollutant
ISO 22197-3:2011 pdf download Read More »
This part of ISO 22090 specifies the construction, performance, and testing of a device employing only magnetic means as transmitting heading devices required by chapter V, SOLAS 1974 (as amended). A Transmitting Heading Device (THD) is an electronic device that provides information about the ship’s true heading. In addition to the general requirements contained in
ISO 22090-2:2014 pdf download Read More »
ISO 22068:2012 specifies the requirements for the chemical composition and the mechanical and physical properties of sintered-metal injection-moulded materials. It is intended to provide design and materials engineers with necessary information for specifying materials in components manufactured by means of the Metal Injection Moulding (MIM) process only. It does not apply to structural parts manufactured
ISO 22068:2012 pdf download Read More »
This part of ISO 21809 specifies the requirements for qualification, application, inspection, testing, handling and storage of materials for plant application of two-layer polyethylene coatings (2-layer PE) applied externally for the corrosion protection of bare steel pipe for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623.
ISO 21809-4:2009 pdf download Read More »
ISO 21670:2014 specifies characteristics for hexagon weld nuts with flange, with sizes M5 to M16 (coarse thread) or D = 8 mm to 16 mm (fine pitch thread), of product grade A. Weld nuts conforming to this International Standard are suitable for use with bolts of property classes up to 10.9 according to ISO 898-1.
ISO 21670:2014 pdf download Read More »
ISO 21572:2013 provides general guidelines and performance criteria for methods for the detection and/or quantification of specific proteins or protein(s) of interest [POI(s)] in a specified matrix. These general guidelines address existing antibody based methods. Methods other than those described in Annex A or Annex B can also detect the POI. The same criteria as
ISO 21572:2013 pdf download Read More »
ISO 21563:2013 specifies the requirements and tests for helping determine whether the elastic aqueous agar and alginate hydrocolloid dental impression materials, as prepared for retail marketing, are of the quality needed for their intended purposes. It also specifies requirements for labelling and instructions for use. NOTE This International Standard specifies no requirements or tests for
ISO 21563:2013 pdf download Read More »