Welcome to this website, where you can query the price of CSA standards, the latest version of CSA standards and the basic introduction of CSA standards.
ASME A17.8/CSA B44.8 applies to elevators permanently installed in a wind turbine tower to provide vertical transportation of authorized personnel and their tools and equipment only. Such elevators are typically subjected to extreme temperatures, humidity variations, and substantial horizontal motions where, by reason of their limited use and the types of construction of the structures […]
CSA B44.8-16 pdf download Read More »
This Standard sets forth methods for both new insallation and replacement installation of factory assembled windows, exterior doors, and skylights that are intended for installation in low-rise buildings and buildings used primarily for, but not limited to, residential occupancy where the windows, doors, and skylights (including window wall) are R, LC, or Cw class within
CSA A440.4:19 pdf download Read More »
This Standard applies to a) fenestration systems covered by AAMA/WDMA/CSA 101/.5.2/A440, including i) vertically sliding windows; ii) horizontally sliding windows; iii) dual-action windows; iv) casement windows, both fixed and operable; v) projecting (awning/hopper) windows; vi)fixed windows; b) curtain wall; and c) garage (vehicular access/rolling) doors.
CSA A440.2:19 pdf download Read More »
This Standard covers asphalt intended for use as hot cement and topcoat in the construction of built-up coverings on roof decks of various types and slopes and in the construction of waterproofing systems.
CSA A123.4-04 (R2018) pdf download Read More »
This Standard gives minimum requirements for ventilators used in buildings which are designed to permit venting of unoccupied spaces to the exterior so as to minimize the unwanted accumulation of condensation, moisture, and excess heat in the building component or assembly. These include a) passive airflow ventilators for buildings; and b) mechanical (powered) airflow ventilators
CSA A93:19 pdf download Read More »
This Standard specifies requirements for the design, manufacture, and quality control of all types of concrete poles.
CSA A14-07 (R2017) pdf download Read More »
This Standard establishes requirements for newly produced compressed natural gas fuel system components, intended for use on natural gas powered vehicles, as listed in Table 1, below:
CSA 12.3-2014 pdf download Read More »
This Standard applies to portable type gas water heaters (herein after referred to as appliance or water heater) for use with propane, butane, or liquefied petroleum gases and mixtures thereof having: a) a regulated pressure; b) a non-regulated pressure.
CSA 11.6:19 pdf download Read More »
This standard applies to newly produced gas appliance connectors constructed entirely of new, unused parts and materials that: Are intended for use with gas utilization equipment that may be mounted on casters or otherwise be subject to movement.
CSA 6.16-2009 pdf download Read More »
Types of Regulators. This standard applies to individual gas appliance pressure regulators, which are not a part of a combination control (see Part V, Definitions), constructed entirely of new, unused parts and materials, hereinafter referred to as regulators, intended for application on individual gas appliances. This standard also applies to negative gas appliance pressure regulators
CSA 6.3-2007 pdf download Read More »