AS Standards

This document specifies a test method for determining moisture content in paper, board and pulps.

This Standard specifies the dimensional, material and marking requirements for steel bolt assemblies comprising steel bolts of property class 8.8, steel nuts of property class 8 with ISO metric coarse pitch series threads, in diameters from 12 mm to 36 mm, and associated hardened and tempered steel washers intended for use in steel structures. This

This Part of the specification applies to rheostatic rotor starters for industrial use intended to start an a.c. induction motor having a wound rotor by cutting out resistors previously inserted in the rotor circuit, to provide means for the protection of the motor against operating overloads, and to cause intentionally the motor to stop.

This Part of the specification applies to two-step autotransformer starters for industrial use, intended to start in the starting position, accelerate an induction motor to normal speed, provide means for the protection of the motor and its associated circuits against operating overloads, and cause the motor to stop intentionally. NOTE: Autotransformer starters with more than

This Standard sets out the method for determining by visual examination the amount of foreign material in coarse aggregate produced from recycled concrete aggregate. The method is appropriate for material up to 75 mm nominal size and tests that fraction of the material retained on the 4.75 mm sieve.

This Standard describes a settling test which may be used in the field or laboratory as a guide to the amount of fine silt, clay and similar materials in fine aggregates. The test is not recommended for fine aggregates known to have more than 10% passing the 75 μm sieve aperture as it is unlikely