AS Standards

(a) shall include the stated purpose for the Services; (b) may include the Client’s design, timing and cost objectives; and (c) where stated in Item 10, shall include a preliminary design;

This Guide sets out procedures for the collection of deposited dust and soil samples to ascertain whether inorganic lead is present in sufficient quantities to cause toxicity in humans. Because infants constitute the most sensitive group as regards sublethal lead toxicity, special emphasis is placed upon the collection of samples from areas with which this

This Standard defines the requirements for quality, sustainable and accurate identification of individuals (clients and providers of healthcare) and organizations in healthcare. It considers the issue of identification as well as the systems (computerized and manual) used to support identification. This Standard covers all identifiers used in healthcare, including but not limited to, national health

This Standard applies to the processing of all animals used in the production of pet meat. The Standard applies to the production of fresh and frozen pet meat derived from animals slaughtered and processed at a processing establishment, as well as wild animals killed in their natural environment. It contains the minimum requirements for hygiene

This Standard specifies requirements for pressure-sensitive adhesive (PSA) labels for general purpose use for paper-based label stock and plastic-based label stock. NOTES: 1 Purchasing guidelines and the main applications of the various tapes are given in Appendix A. 2 Label stock is intended for conversion (by the label stock converter) to many of the plastic

This Standard provides a measure of the capability of a machine made cigarette, positioned on a standard substrate, as specified in Appendix A, to generate sufficient heat to continue burning and thus potentially cause ignition. This method is applicable to machine-made cigarettes that burn along the length of a tobacco column including filtered and unfiltered

This Standard specifies requirements for the selection, installation and commissioning of copper plumbing, gas and waste water systems. Some aspects of design are also specified.

This Standard specifies requirements for metal-bodied and plastic-bodied ball valves for installation between the reticulation water main and the property water meter in nominal sizes DN 15, DN 20, DN 25, DN 32, DN 40 and DN 50 at allowable operating pressures of PN 16 and PN 25 and continuous operating temperatures not exceeding 60°C.