Example problems illustrating the use of the design-by-rule and design-by-analysis methods in ASME B&PV Code, Section VIII, Division 2 are provided in this document. Example problems are provided for all calculation procedures in both SI and US Customary units.
ASME PTB-3:2010 pdf download Read More »
The risk analysis principles, guidance, and implemen-tation strategies presented in this Standard are broadly applicable; however, this Standard has been specifically developed for applications involving fixed pressure-containing equipment and components. This Standard is not intended to be used for nuclear power plant com-ponents; see ASME BPV, Section XI, Rules for Inservice Inspection of Nuclear Power
ASME PCC-3:2017 pdf download Read More »
Repair welding considerations in this Article are applicable to pressure vessels for refinery, petrochemi-cal, power generation, and other services where the requirements ofthis Article apply. Table 1 provides guid-ance for the applicability of repair welding for Cr–Mo steel pressure vessels.
ASME PCC-2S:2015 pdf download Read More »
The bolted flange joint assembly (BFJA) guidelines described in this document apply to pressure-boundary flanged joints with ring-type gaskets that are entirely within the circle enclosed by the bolt holes and with no contact outside this circle. 1 By selection of those features suitable to the specific service or need, these guidelines may be used
ASME PCC-1:2010 pdf download Read More »
The bolted flange joint assembly (BFIA) guidelines described in this document apply to pressure-bound-ary flanged joints with ring-type gaskets that are entirely within the circle enclosed by the bolt holes and with no contact outside this circle.’ By selection of those features suitable to the specific service or need, these guidelines may be used to
ASME PCC-1:2000 pdf download Read More »
This Part applies to all PASE defined in this Standard.
ASME PASE:2019 pdf download Read More »
The scope of this Standard is the standardization of safety and performance requirements for portable auto-motive service equipment(PASE) including, butnotlim-ited to, the following: (a) attachments, adapters, and accessories (b) hydraulic hand jacks (c) transmission jacks (d) engine stands (e) vehicle support stands (f) emergency tire-changing jacks (g) mobile lifts (h) service jacks (i) wheel dollies
ASME PASE:2014 pdf download Read More »
The scope of this Standard is the standardization of safety and performance requirements for portable auto-motive lifting equipment including: (a) hydraulic hand jacks (b) transmission jacks (c) engine stands (d) vehicle support stands (e) mechanical screw jacks (f) mechanical bumper jacks (g) scissors jacks (h) mechanical frame jacks (i) upright-type mobile lifts (j) service jacks
ASME PALD:2003 pdf download Read More »
SectionIST establishes the requirements for preservice and inservice testing and examination of certain compo-nents to assess their operational readiness in light-water reactor nuclear power plants. It identifies the compo- nents subject to test or examination, responsibilities,methods, intervals, parameters to be measured and eval-uated, criteria for evaluating the results, corrective action, personnel qualification, and record keeping.These
ASME OMA CODE:2011 pdf download Read More »
One unique aspect of the behavior of graphite is the material’s temperature response. Graphite, unlike other materials, increases in strength with increasing temperature. Tensile strength increases of ~50% are typical,with the strength increasing with temperature until the onset of plasticity at approximately 2000°C. This behavior requires the exclusion of oxidizing gases, such as air, to
ASME NTB-4:2021 pdf download Read More »