This part of IEC 63005 describes test methods on evaluating performance of basic functionalities of EVDR described in IEC 63005-1 .

This part of IEC 63005 describes basic requirements for event video data recorders (EVDRs) for road vehicle accidents, used for identifying and analysing causes of accidents based on video from a front-mounted camera and other information obtained before and after such events. In addition to video from a front-mounted camera and vehicle behaviour, these products

This part of IEC 62969 specifies procedures and definitions for measuring the efficiency of the wireless power transmission system for the automotive vehicles sensors. This document deals with the power range below 500 mW.

This part of IEC 62957 specifies requirements for data preparation and data injection when using the semi-empirical method for performance evaluation of detection and radionuclide identification. This document recommends approaches for results interpretation and consolidation and establishes a method to share data and analysis results. This part 1 of the standard is specific to the

This part of IEC 62951 specifies terms, as well as the test method and report of sheet resistance of the flexible conducting film under bending and folding tests. The measurement methods include the 2-point probe, 4-point probe and Montgomery method, which can be applied to in-situ and ex-situ measurement and the measurements of anisotropic sheet

This part of IEC 62951 specifies terms, definitions, symbols, configurations and evaluation methods that can be used to evaluate and determine the performance characteristics of flexible thin-film transistor (TFT) devices. This document specifies test methods and characteristic parameters for accurately evaluating the performance and reliability in practical use of flexible TFT devices under the bending

This part of IEC 62923 specifies standard alert identifiers and reserved cluster identifiers to be used when applying bridge alert management. The intent is to reduce the number of different identifiers used for similar alerts as much as possible.