The economic advantages of Electronic Data Interchange (EDI) are widely recognized. However,the cost of setting up an EDI relationship has been very high due to the need for a detailed bilateral business and technical agreement between the involved business partners. The initial high cost of establishing such an agreement does not justify short term partnerships. […]

ISO 14628:2012 specifes a test method for rolling contact fatigue of silicon nitride ceramics under stepwise loading that is carried out at room temperature. This test may be used as follows: relative comparison of the rolling contact fatigue performance, a pass/fail test for material qualifcation of rolling elements or choosing an appropriate load level for

ISO 14603:2012 describes a test method for the determination of open-hole tensile strengths of ceramic matrix composite materials with continuous fbre reinforcement at room temperature. This method applies to all ceramic matrix composites with a continuous fbre reinforcement, bi-directional (2D), and tri-directional (xD, with 2 < x ≤ 3), tested along an arbitrary axis of

ISO 14581:2013 specifies the characteristics of hexalobular socket countersunk flat head screws in product grade A and with threads from M2 to M10 inclusive and with reduced loadability according to Table 3. If, in special cases, specifications other than those listed in this International Standard are required,they can be selected from existing International Standards, e.g.

ISO 14436:2010 describes the specification and preparation of standard tap water, of conductivity between 40 mS/m and 150 mS/m, for drainability measurements. This International Standard is applicable to all kinds of pulps. NOTE ISO 14487 [1] describes the specification and preparation of standard distilled/deionized water.

ISO 14323:2015 specifies specimen dimensions and testing procedures for impact tensile shear and cross-tension testing of resistance spot and embossed projection welds in overlapping sheets,in any metallic material of thickness 0,5 mm to 4 mm.

ISO 14291:2012 defnes terms relevant to quadrupole mass spectrometers (QMSs) and specifes the parameters required for specifcation by QMS manufacturers necessary for proper calibration and for maintaining the quality of partial pressure measurement. This International Standard applies to QMSs with an ion source of the electron impact ionization type. Such QMSs are designed for the

ISO 14287:2012 specifes requirements for materials based on metals, polymers, back metals and pivots for the manufacture of tilting pad bearings.