This standard defines the technical requirements that can reduce or control the VR sickness caused by the HMD-based VR content service. Hence, the VR content service mentioned in this document is considered HMD-based VR content service by default unless otherwise mentioned. The requirements cover the followings: — Content design for VR sickness reduction — The

The scope of this standard includes performance estimation accuracy for complex processors like Very Long Instruction Word (VLIW) core and complex contention scenarios, description of caches to include uncached memory regions and caches for subsets of memories, properties for coarse power consumption estimation, and reusability by separating eXtensible Markup Language (XML) files for processor description

This standard defi nes and describes the technical requirements, tests, inspection rules, sign, and package of insulation-piercing connectors (IPCs) used in aerial insulated cable lines, bridges and culverts, galleries,tunnels, mines, cable wells, etc., for rated voltages up to 12 kV.

This guide is primarily concerned with the grounding system design for ground-mount photovoltaic (PV) solar power plants (SPPs) that are utility owned and/or utility scale (5 MW or greater). The focus of the guide is on differences in practices from substation grounding as provided in IEEE Std 80. This guide is not intended for the

This guide describes the energy efficiency technology evaluation of electric power fittings. It is applicable to electric power fittings that are in direct contact with electric power conductors.

This guide identifies the mechanisms and analytical approach for ac interference effects on conductive linear facilities due to the operation of co-located electric transmission lines. The common mechanisms for ac interference, including magnetic inductive coupling, capacitive coupling, and conductive voltage transfer through soil are discussed. Included are general guidelines and considerations for performing detailed ac

This guide covers the selection and procedures for electrical cables and cable systems installed in hazardous (classified) locations on oil and gas land drilling rigs.

This standard describes the criteria for the application and testing of combustion turbine-generator units as Class 1E standby power supplies in nuclear power generating stations. Figure 1 shows the boundaries of systems and equipment included in the scope of this standard. Site testing is covered in Clause 7, and the boundaries for site testing are