1.1 This practice covers testing to evaluate chemical constituents, chemical and physical properties of compounding materials, and compounded and cured rubbers, which may frequently be conducted by one or more test methods. When more than one test method is available, two questions arise:Which test method has the better (or best) response to or discrimination for […]

1.1 This practice covers the steps necessary to determine if a site is ready for closure with emphasis on general sampling techniques and how to determine if the agreed upon level of remediation has been achieved. 1.2 A minimum of statistical procedures is used in this practice.

1.1 This practice covers a test method for the evaluation of granular activated carbon (GAC) for the adsorption of soluble pollutants from water. This practice can be used to estimate the operating capacities of virgin and reactivated granular acti-vated carbons. The results obtained from the small-scale column testing can be used to predict the adsorption

1.1 This specification establishes requiremnents for chemi-cally blown cellular rubber. 1.2 In the case of confict between the provisions of this specification and those of detailed specifcaions or test meth-ods for a particular product, the latter shall take precedence. 1.3 Unless specifially stated otherwise, by agreement be-tween the purchaser and the supplier, all test methods

1.1 This test method covers the corrosiveness of hydraulic and lubricating fluids to a bimetallic galvanic couple. NOTE 1—This test method replicates Fed-Std No. 791, Method 5322.2.It utilizes the same apparatus, test conditions, and evaluation criteria, but it describes test procedures more explicitly. 1.2 The values stated in SI units are to be regarded as

1.1 This guide provides techniques to be used for the evaluation of the measurement performance of on-line coal analyzers. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility ofthe user of this standard to establish appro-priate safety and health practices and

1.1 This specification covers the requirements for HFC-236fa as a fire-fighting medium. 1.2 This specification does not address the fire-fighting equipment or hardware that employs HFC-236fa or the condi-tions of employing such equipment (for example, hand-helds,fixed installations, and so forth).

1.1 This test method covers the determination technique for a dip tube of a mechanical pump dispenser. 1.2 The values stated in both inch pound and SI units are to be regarded separately as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use.

1.1 This test method covers the determination of the peak force-to-actuate, sometimes called force-to-actuate (FTA), of a mechanical pump dispenser. 1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.1 This test method covers the determination of the hy-draulic conductivity, or the permeability relative to water, ofany porous medium in the laboratory, in particular, the hydrau-lic conductivity for water in subsurface materials, for example,soil, sediment, rock, concrete, and ceramic, either natural orartificial, especially in relatively impermeable materials ormaterials under highly unsaturated conditions. This testmethod