1.1 This practice stipulates the types, names, and sizes of Codes for those material types specified in Table 1. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are likely not to be exact equivalents; therefore, each system shall be […]

1.1 This test method covers the determination of dimen-sional changes in the lengthwise and width-wise direction and distortion likely to occur when pile floor coverings are exposed to various conditions of moisture and heat. This method is applicable to all pile floor coverings including carpet module form. 1.2 This method is applicable to machine made

1.1 This test method covers the determination of total nonaromatic hydrocarbons and monocyclic aromatic hydrocar-bons in benzene, toluene, ethylbenzene, p-xylene, o-xylene, styrene and mixed xylenes by gas chromatography. The purity of benzene, toluene, ethylbenzene, p-xylene, o-xylene, styrene and mixed xylenes is also calculated. Similar test methods,using the internal standard calibration technique and the external standard

1.1 This test method covers the gas chromalographic pro-cedure for the quantitative determination of organic oxygenates in C2, C3, C4, and C5 matrices by multidimensional gas chromatography and fame ionization detection. This test method is applicable when the hydrocarbon matrices have a final boiling point not greater than 200 °C. Oxygenate com-pounds include, but are

1.1 This test method covers a procedure for determining the friction and wear behavior of grease lubricated plastic socket suspension joints, for validation of suspension joint greases and quality inspection for those greases under high-frequency linear-oscillation motion using the SRV test machine. 1.2 The values stated in SI units are to be regarded as standard.

1.1 This test method covers the determination of the strength behavior of cylindrical specimens of frozen soil,subjected to uniaxial compression under controlled rates of strain. It specifies the apparatus, instrumentation, and proce-dures for determining the stress-strain-time, or strength versus strain rate relationships for frozen soils under deviatoric creep conditions.

1.1 This test method covers the determination of puncture properties of plastic films, over a range of test velocities. 1.1.1 ASTM Terminology Standard D883 has defined film as having a thickness not greater than 0.25 mm. Plastic materials having a thickness above this limit are not to be excluded from use unless shown to be

1.1 This test method covers the laboratory procedure for determining the relative mileage of news inks on newsprint.The test method utilizes a proofing press, analytical balance and a reflection densitometer. 1.2 This test method is intended for black oil-based news inks that dry by penetration (that is, letterpress or web offset) and for which a

1.1 This test method describes the procedures to determine the gassing characteristics due to thermal stress at 120°C of insulating liquids specifically and without the influence of other electrical apparatus materials or electrical stresses. This test method was primarily designed for insulating mineral oil. It can be applied to other insulating liquids in which dissolved

1.1 This test method covers the determination of the corro-siveness to copper of aviation gasoline, aviation turbine fuel,automotive gasoline, natural gasoline, or other hydrocarbons having a vapor pressure no greater than 124 kPa (18 psi),cleaners (for example, Stoddard solvent), kerosine, diesel fuel,distillate fuel oil, lubricating oil, and other petroleum products.