1.1 This specification covers self-contained, globe style,pressure-reducing valves for use in water systems of shipboard installations. These valves are limited to discharge pressure settings of 200 psig (1379 kPa) and below. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units […]

1.1 This guide covers minimum requirements for the scope of performance of first responders who may be responsible for the initial care of sick and injured persons of all ages in the prehospital environment. 1.2 This guide includes objectives based on an individual’s acquired knowledge, including signs and symptoms; patient assessment; basic life support/cardiopulmonary resuscitation

1.1 This specification 2 provides the minimum requirements for the design, fabrication, pressure rating, marking, and testing of steam traps and drains. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not

1.1 This practice covers the determination of the stability in storage of liquid enzyme-based, terpene-based, and solvent-based chemical cleaning compounds used to clean the exterior surfaces of aircraft. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.1 These test methods cover sampling and analysis of high purity water from water purification systems and water trans-mission systems by the direct sampling tap and filtration of the sample collected in the bag. These test methods cover both the sampling of water lines and the subsequent microbiological analysis of the sample by the culture

1.1 This test method provides a procedure for determining the resistance ofresilient floor covering to surface deterioration when exposed to various chemical reagents. This test method is not intended as a staining test nor as a method to judge surface and appearance restoration of the sample after exposure to chemical reagent. 1.2 The values stated

1.1 These terms and definitions are related to printers operated by computers.

1.1 This specification specifies shape, size, spacing, and shading of letters and numerals to be used aboard ship. 1.2 Characters are ofFive Types: 1.2.1 Type 1—Plain letters and numerals (16 units). 1.2.2 Type 2—Block letters and numerals (12 units). 1.2.3 Type 3—Type 2 characters with shading (shading—1 unit). 1.2.4 Type 4—Block letters (10 units) and

1.1 This specification covers the chemistry requirements for wrought stainless steels used for the manufacture of surgical instruments. The data contained in Tables 1-4 of this specification, including typical hardness values, common heat treating cycles, and examples of selected stainless steels that have been used for surgical instruments, is provided for reference only. Mechanical property

1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, ring stiffness, flattening, joint systems, and a form of marking for large diameter, 10 to 132 in. (250 to 3355 mm), inside diameter based polyethylene (PE) pipe of profile wall construction and with bell and spigot, heat fusion, extrusion welded or elctro- fusion