1.1 This guide presents briefly some generally accepted methods of statistical analyses which are useful in the inter-pretation of service life data. It is intended to produce a common terminology as well as developing a common meth-odology and quantitative expressions relating to service life estimation.

1.1 This guide covers procedures to be implemented prior to the application of cathodic protection for evaluating the suit-ability of a tank for upgrading by cathodic protection alone. 1.2 Three procedures are described and identified as Meth-ods A, B, and C. 1.2.1 Method A—Noninvasive with primary emphasis on statistical and electrochemical analysis of external site

1.1 This lest method covers procedures for evaluation of stness corrosion cracking (SCC) resistance by the breaking load lest method, a concept which uses residual strength as the measure of damage evolution (in this case enviroumentally assisted cracking).

1.1 This test method covers laboratory procedures for de-termining the sliding wear of ceramics, metals, and othercandidate wear-resistant materials using a linear, reciprocatingball-on-flat plane geometry. The direction of the relativemotion between sliding surfaces reverses in a periodic fashionsuch that the sliding occurs back and forth and in a straightline. The principal quantities of interest are

1.1 The purpose of this guide is to establish a procedure to select cleaning agents, both solvents and water-based detergents, for oxygen- enriched systems. This includes laboratory-scale tests for cleaning. ffectiveness. materials compatibility, and oxygen compaibility.

1.1 This terminology defines terms related to the compat-ibility and sensitivity of materials in oxygen enriched atmo-spheres. It includes those standards under the jurisdiction of ASTM Committee G04. 1.2 The terminology concentrates on terms commonly en-countered in and specific to practices and methods used to evaluate the compatibility and sensitivity of materials in oxygen. This

1.1 This test method covers a procedure for conducting stress-corrosion cracking tests in an acidified boiling sodium chloride solution. This test method is performed in 25 % (by mass) sodium chloride acidified to pH 1.5 with phosphoric acid. This test method is concerned primarily with the test solution and glassware, although a specific style ofU-bend

1.1 This practice describes the procedure for the preparation of single- and double-sded contaminated malle test coupons for the evaluation of cleaning agents, It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxyen-eniched systems and components. It also is applicable to other syslems where contamination is a concem.

1.1 This practice covers the evaluation of amosphenic galvanic corrosio of any anodie material that can be made into a wine when in conlact with a cathodic maleril that can be made into a threaded rod.