1.1 This specification covers requirements for electrolyti-cally formed porous oxide coatings on aluminum and alumi-mum alloy paurts in which appearance, abrasion resistance,eletrical properties, and protection against corrosion are important. Nonporous, barrier layer anodic coatings used for electrical capacitors are not covered. Seven types of coatings as shown in Table 1 are provided. Definitions and typical […]

1.1 This specification covers the requirements for electrode-posited tin-lead coatings on fabricated articles of iron, steel,copper, and copper alloys, to protect them against corrosion (Note 1), to improve and preserve solderability over long periods of storage, and to improve anti-galling characteristics.

1.1 This specification 2 covers rod of low-carbon nickel-chromium-molybdenum alloys (UNS N10276, N06022,N06035, N06455, N06058, and N06059)*, low-carbon nickel-molybdenum-chromium (USN N10362), low-carbon nickel-molybdenum-chromium-tantalum (UNS N06210), low-carbon nickel-chromium-molybdenum-copper alloy (UNS N06200),and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service.

1.1 This test method covers the double shear testing of aluminum and aluminum alloy rivets with round, solid shanks and cold-heading wire and rod.2 NoreE 1- Exeptons to this test method may be ncesary in individuall specifications or methods for tests for a particular material.

1.1.2 Nickel-iron-chromium-tungsten alloy UNS N06674 is normally employed in service temperatures above 1 100°F (593°C) where resistance to creep and rupture is required, and is annealed to develop optimum properties in this temperature range.

1.1 These test methods cover the tension testing of wrought and cast aluminum- and magnesium-alloy products, with the exception of aluminum foil, 2 and are derived from Test Methods E8, which cover the tension testing of all metallic materials. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units

1.1 This test method specifies a method for the determina-tion of tap density (packed density) of metal powders and compounds, that is, the density of a powder that has been tapped, to settle contents, in a container under specified conditions.

1.1 This specification2 covers welded, cold-worked, and annealed nickel- chromium- iron alloy (UNS N06600,3 N06603,N06025, and N06045) pipe for general corrosive service and heat-resiting applications. 1.2 This specification covers outside diameter and nominal wall pipe shown in ANSI B36. 19. Pipe having other dimen-sions may be furnished provided such pipe complies with all other requirements

1.1 This specification covers silver- coated, round, copper-clad steel wire for electronic application. 1.2 Silver coatings in mass percentages of the total mass of the coated wire are as follows: 1.25, 2.5, 4.0, 6.1, and 8.0.

1.1 This spcification2 covers three grades of zirconium and zirconium alloy forgings (see 4.1). 1.2 The values stated in either SI units or inch- pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining