1.1 This test method covers the measurement of the elastic and short-term creep characteristics ofconductors for overhead power lines. 1.2 Stress-strain data from tests performed in accordance with IEC 61089 are compliant with this standard.

1.1 The following procedures and practices are intended to provide guidelines for processing and quality control that will provide acceptable results for the intended end use, keeping in mind the varying quality of the castings available. 1.2 The recommendations are based on what have been acceptable industry standards and experiences for over 40 years of

1.1 This standard details a laboratory method to accelerate the effects of exposure to hygroscopic corrosive chloride compounds on electroplated chromium components. It is applicable to any substrate and coating system that utilizes electroplated chromium as the final metallic coating. 1.2 Field experience has shown that hygroscopic chlorides are significantly more aggressive toward chromium electro-plated

1.1 This specification covers a commercial zinc-aluminum alloy in ingot form for remelting for the manufacture of thin wall pressure die castings as designated and specified in Table 1. 1.2 Systems of nomenclature used to designate zinc and zinc-aluminum (ZA) alloys used for casting are described in Appendix X1.

1. I This specifcation establishes the requirements for low leaded brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloys UNS No. C36300, C36500, C37000, C37100 and C37700 suitable for high-speed screw machining applications. Nore 1- Refer to Specifcation B124/B124M when purchasing bar or rod for forging production.

1.1 This specification covers titanium and titanium aloy ingots as follows: 1.1.1 Grade 1- UNS R50250. Unalloyed titanium, 1.1.2 Grade 2- _UNS R50400. Unalloyed titanium, 1.1.3 Grade 3- UNS R50550. Unalloyed titanium, 1.1.4 Grade 4 _UNS R50700. Unalloyed titanium,

1.1 This specification covers fiber reinforced, aluminum matrix composite core wire used for mechanical reinforcement in the manufacture of aluminum conductor, composite rein-forced (ACCR). This wire consists of continuous filament fibers of aluminum oxide in a matrix of aluminum.

1.1 This test method for determining the intemal tensile or compressive stress in applied coaings is quandiadive. It is aupplicable to metallie layers that are applied by the processes of electroplating or chemical deposition that exhibit intermal tensile or compressive stress values from 500 1to 145 000 psi (3.45 to 1000 MPal.

1.1 This standard describes a method for measuring the density of powder metallurgy products that usually have surface-connected porosity. 1.2 The density of impermeable PM materials, those mate-rials that do not gain mass when immersed in water, may be determined using Test Method B311.

1.1 This guide contains practices for specifying and evalu-ating the electrical contact performance of crimped-type ter-minations with solid or stranded conductors. 1.2 This guide provides information relevant to the electri-cal contact performance of a crimped wire termination. It does not cover other aspects of selection and use of crimped terminals.